Search results

  1. I

    winky blinkyI

    I recently purchased a yamaha winky blinky for a 1996 txru 250 hp outboard. I hooked it up and got a 33 code followed by a 34 code. No 34 code listed in my yamaha manual? Can anyone help i would appreciate it.
  2. I

    88 xr-4 rough idle

    bought boat on ebay and motor idles very rough meaning had to idle at 1300-1400 rpms or it would stall in water. Did a link/sync. Went through carbs and did not see anything obvious so cleaned and new gaskets. Found rectifier was bad and replaced which ran a little better. Did check on stator...
  3. I

    89 xr-4 150 black max reed advice

    i have been dealing with an issue of rough idle/ having to raise idle speed to stop from stalling. Have done a link and sync changed plugs, checked spark to see if firing on all cylinders. Still idling rough and noticed plugs always look wet when i check them. Removed carbs and inspected reeds...
  4. I

    xr-4 idles very rough

    I am new to this forum but have learned alot just from looking at some of the posts. I have a 89 xr-4 that i have been trying to get to idle under 1000 rpms. It runs fine at wot. I adjusted the timing and linkages the way my clymer manual told me but had one question. It said to adjust the...
Top