Search results

  1. 5

    1994 suzuki 9.9

    Hey guys I am at my old mans house and they have a 94 9.9 and it is overheating. we put a new impeller in and checked all the passages and they all seem clear . when I start the engine water spits out but stops immediatly and then nothing comes out at all. i have taken the thermostat out and...
  2. 5

    63 super seahorse popping out of drive

    Hey guys, I was out for a cruise last night and I started having some issues with the engine coming out of drive. at first it popped out and then would go back into drive but after a few minutes it would not stay in drive . I have tried it with the cable off and holding the shift lever down ...
  3. 5

    does worn driveshaft need replacing?

    Hey guys I am having some leakage in my lower unit in my 63 28hp I am getting a seal kit but my driveshaft is worn around the seal area , so my question is will the new seal take up the gap or should I replace the driveshaft or is there another seal I can put in with a smaller I.D?
  4. 5

    1963 28hp super seahorse high rev troublshooting help

    hey gang I just went to test float my boat I have almost finished restoring a 1959 Larson Pla-Boy and I am having some issues with the engine . It is 63 28hp super seahorse it doesnt want to rev very high , seemed to run great at home in a tank but when I put it in the lake and in gear it wont...
  5. 5

    1963 28hp super seahorse wiring help......

    hello everyone, I have recently restored a 1959 14" larson playbouy I have purchased a 1963 28hp super seahorse with electric start. My problem is I would like to have forward controls and ignition as well as accessories but I only see two wires coming from the engine one is a power wire...
Top