Search results

  1. W

    Just want to say thanks!

    After several questions, and a TON of reading on here. I got my 75 Evinrude 9.9 running great. A lot of my issues was the tiller handle. It was bent slightly, the shaft going through was hard to turn, and the gears were ground down. I swapped it out for the one off my spare parts 15hp and fired...
  2. W

    Carb setup on Evinrude 9.9

    I have a 75 Evinrude 9.9. I rebuilt the carb and reinstalled it. I noticed when I installed it that there was a set screw on the Pawl - Starter Interlock? How do I set this? I can't seem to find any information on it. I replaced it at the same time, just not sure how to adjust it properly...
  3. W

    Sludge from prop

    I've searched and read that milky oil coming from the center of the prop is just normal. Unburnt fuel/oil. Today I ran my 9.9 on muffs for a while tuning etc. here's a picture from it. Is this really normal?
  4. W

    Evinrude 60 no forward or reverse

    The other day we were heading out across the lake to a park for the day. We got half way and I noticed the boat bouncing up and down like we were hitting waves, but it was dead calm. Then it was like the engine popped out of gear and revved up. I shut it down and checked to make sure the prop...
  5. W

    Exhaust oil in pump

    I've been working on this Evinrude 9.9 I got for free. I dropped the leg on it and found this: Why is there oil and exhaust chunks/gunk in with the water pump? It's a mess lol. Should I power wash it out on the lower and upper legs? What do I need to do to stop this from happening? Thanks...
  6. W

    Evinrude 9.9

    So i was fortunate enough to get a couple motors from a co-worker. He gave me a decent and running 9.9 and a 15 parts motor. I have to replace a few seals and water pump on the 9.9, but overall its in good shape. The 15 is pretty much junk. Looks like it blew right up lol not much salvageable on...
  7. W

    Johnson controls

    Hey, I got a boat givin to me. I took it out for the first time last night and had a blast it's a 16' Sangster w/Evinrude 60, Johnson controls. It goes into gear (forward and reverse) right away when the lever is pushed or pulled as it should. But in order to get throddle I have to push it...
  8. W

    Convert 7 pin to 4

    I have this connector on my trailer currently I want to change it to a basic flat 4. Can someone point me to a basic tutorial? Thanks
  9. W

    New boat and trailer

    Hey, new to here and new to boats. I was given a boat w/trailer for free. I've been reading like mad trying to learn all I can. I'm looking at the front of the trailer and I'm noticing that it looks like the stop pad for the boat Is way too at back? Looks like the boat has hit the pully several...
Top