Search results

  1. K

    F75TLR stalling at idle rough idle

    I believe the motor is a 2006 but not sure. Boat sat for a year did not stabilize the fuel went to use last year had rough idle and would bog down under load and would not go fast. Boat sat for another 8 months untouched same fuel. Fast forward now: I assumed it was a fuel problem and the VST...
  2. K

    shift rod height 1999 90 hp J90PLEEB

    Trying to figure out the correct shift rod height for my motor. I had to change out my O rings on my shift rod. My manual is one for multiple engines and I cant seem to know which engine I have, is it 60 deg or 90 degree? is it loop or crossflow? I know from my model number the motor is a 20...
  3. K

    1999 90 hp shifting problem

    Its very hard to shift in fwd reverse or neutral, its kind of stuck in neutral. I removed shift cables and cables shift freely. I tried to shift linkages on motor going to lower unit and it wont shift, even trying with big pliers, something seems to be stuck in lower unit. I have not pulled...
  4. K

    Full FWC plumbing help LM318

    LM318 with log style manifolds. Current manifold set up is OSC826 manifolds, 689 riser, 794 elbow. Most of the set ups I have seen block flow between manifold and riser. Then the riser/elbow are salt water cooled. Is it possible to block flow between the riser/elbow making the riser also...
  5. K

    1988 johnson 110 hp idle problem

    When I start my motor the idle will be high. I adjusted the idle cable at the engine so the stop bolt is bottomed on the cam. If I rev the throttle or put in gear and go fast when I go back to neutral it will be idiling high again. If I pull off the engine cover and push the cam back down it...
  6. K

    how to start f100 without controls

    I have a 1999 F100 on an engine stand, I dont have controls with the engine. How can I start it up on an engine stand? I have a remote starting switch just not sure what I need to jump, wire, etc.... Thanks
  7. K

    Nice McKee Craft for sale no motor 172 black water

    http://annapolis.craigslist.org/boa/2649493340.html
  8. K

    Is 115hp too much for 172 blackwater?

    I just purchased a 2002 172 blackwater without a motor. I see most of them have a 90hp. Does anybody have a 115hp on one? I read it can take up to a 115hp engine. My kids are getting bigger and trying to pull a skier with a couple people in the boat I want all the motor i can for the boat...
  9. K

    5.7L PCM high idle issue

    Hello, I have a 22 shamrock boat with a stock PCM 5.7 liter throttle body injected motor (S/N of motor SLL PRL10 TBI). I believe the motor is a 1996, and has a MEFI 2 ECM. I have attached a picture of the ECM, not sure if this ECM is original I have only had the boat a year. I have been...
  10. K

    How to remove 1999 yamaha 115 motor.

    Whats the best way to remove the motor, is there a place to thread in any hooks inside the motor? I have a rather large tree branch that I use to pull engines and a 2 ton chain fall. I am just not sure the best way to strap the engine for lifting. I plan on placing it on a pallet in the back...
  11. K

    1999 yamaha 115 pin to set trim???

    I just bought a 17' proline with a 1999 yamaha 115 OB. The motoor is a long shaft and the boat is suppose to have a short shaft engine. The guy did a really nice job building the extension bracket, See pictures. My problem is the boat seems to bounch up and down when cruising. I have the...
  12. K

    carb identification

    I have a 1999 115hp TXRY. I called yamaha because i could not find my model number in that year and I was told I need to use year 2000 when looking up parts. I am having carb problems and might have to buy other ones. My carbs say on them: Top= 6e515 (small S) 621400-D81 (small P) 9Y01B...
  13. K

    1999 Yamaha 115 won't run

    I just purchased a boat with a 1999 Yamaha 115 TXRT V4. The boat sat for 2 years and has not been run. I put fresh gas in it and can't get it started. I assume the carbs are clogged up with gummed fuel but I figured I would check here first for opinions. I am going to check for spark first...
  14. K

    starter bolt length?

    1999 3.0 GS PWTR. Both my starter bolts sheared off and were laying in the bilge. I read all the info on the starter issue and plan on fabricating the bracket for the back of the starter. I want to verify what length both starter bolts are suppose to be as I think one of mine is too long...
  15. K

    Hesitation when throttling up

    1998 3.0GS PWTR. I noticed the boat has a hesitation when punching the throttle. If you are going slow and go to pull up a skier or something it will hesitate/sputter for about 3-4 seconds then it takes off and runs fine. This is what I have done to try to solve this problem: 1. I bought a...
  16. K

    Volvo penta SX stuck in forward

    Little history, I grew up working on boats. I have built boats, most of my experiance is work boats. I currently own several other boats and I do all my own maintenance. I have always had straight inboards and have no experience with outdrives. My wife wanted a small Girly boat to run...
  17. K

    volvo penta 3.0L high idle?

    I have a holley 2barrell 1998 3.0L volvo penta. Pulled the carb off to change the exhaust manifold, when I put it back on the idle was too high. The carb was giving me problems so I boaught a OEM rebuild kit and pulled the carb apart. I took my time cleaned everything real good. The carb is...
  18. K

    motor identification?

    I have a 1999 four winns 170 Horizon I just purchased recently. I am trying to buy a service manual for my boat. My volvo book says that the motor identification should be on the valve cover, it appears my valve cover has been changed/painted so there are no markings on it. I wrote down the...
  19. K

    1985 yamaha 115 hessitation at about 2k rpm

    Posting this for my friend. He has a (I think 1985) 115 yammy. He just rebuilt the carbs. The motors idles nice and at WOT will run fine all day long. At around 2 k it has a hesitation. Just trying to get some ideas what to do to fix the problem. Thanks
  20. K

    3.0L Volvo penta milky oil update

    Sorry dont know how to delet post, I moved update back to my original post under volvo penta forum.
Top