Search results

  1. P

    1999 Tohatsu M40D2 tilt/trim problem

    I'm having a problem with the tilt/trim on this motor. The tilt cylinder will tilt it all the way down, but will not raise it up. The only way I can get the motor tilted up is by turning the screw valve to manual and lifting the engine up. It sure seems like it's a trapped air problem. I...
  2. P

    EZ Loader trailer with KNOTT bearing hubs

    I just bought a 13' Boston Whaler on a 2010 EZ Loader trailer. One of the bearings is rough and loud and needs to be replaced. I just found out the trailer hubs are made by KNOTT and are waterproof and are not intended to be greased or replaced. I
  3. P

    Need help with anchor lights

    I have a problem with my anchor light not coming on when I turn on the anchor light switch, and could use some help. Situation: My navigation lights on my cruiser consist of the red and green bow lights, a white stern light, and a combination masthead light/white all around light. They are...
  4. P

    Eliminate chalky deck runoff

    I have a 32' express cruiser. The tan nonskid front deck is dirty from having sat under shrink wrap for two years. Worse yet, when I scrub the deck with boat soap or after it rains I get this white milky looking residue running down over the darker colors of the hull, and over the windows. I...
  5. P

    Avon model year?

    I have an Avon model AD-11. Serial no. is 1496700. Can anyone tell me the year of manufacture? Thanks.
  6. P

    Avon year of manufacture/

    I have an Avon model AD-11. Serial no. is 1496700. Can anyone tell me the year of manufacture? Thanks.
  7. P

    Can my Avon inflatable be repaired?

    I have an old Avon inflatable model AD-11, ser # 1496700. The squirrels have gotten into it while stored in my shed and have chewed a hole through the bottom of the boat. The opening is located on the flat part of the bottom, and is approximately 6" long be 2" wide? In other words, the opening...
  8. P

    vent drain plug gasket 57 Johnson

    i have a 57 Johnson that I am winterizing. I just checked the oil in the lower unit and it is milky. There were no seals on either the vent or drain screws, so I am assuming that is where the water is getting in. At least I will install new seals and then set in a barrell of water for a few days...
  9. P

    Winterize 7.5 hp Johnson

    I have my 57 Johnson 7.5 hp motor that I need to store for the winter. I have not put any fuel conditioner in the gas or sprayed any fogging oil in the carburetor or checked the gearcase oil (which I will do). I don't have any good way to run the motor to do any winterizing short of buying a 55...
  10. P

    57 Johnson 7.5hp impellor replacement

    I bought a '57 Johnson 7.5 hp for use on my inflatable. It runs great (most of the time), and is a real conversation starter as my wife and I cruise around the marinas. Twice this fall it overhated as I was idling. I noticed it immediately and shut her down. After cooling it started and ran OK...
Top