The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have a 12 foot aluminum that has the threaded drain plug hole in the floor, I am unable to put a new plug in as the threads on the housing are stripped, I would like to plug this hole and install a transom plug but I am unsure of what to use to plug the old hole with. If I filled it with JB...
I have a f115 and the steering is rather stiff, is there a friction setting on these motors that can be adjusted to rule out a cable or some sort of seizure in the pivot point of the motor? and if so where would it be located.
I have a 1996 yamaha 4 stroke outboard and the power trim is making a loud noise when putting the motor down on the 2 rams almost like the rams need to be lubricated, is there a way to lubricate these without causing any damage?
I have removed an old transducer, I filled the holes with a 5 min epoxy then countersunk the hole and filled it with marine grade resin one of the holes went right through. I want to put gel-coat paste over the repair but I need to make sure it will be water tight first.
Will this work?
I have a 1996 Larson 174 this boat was not manufactured with side windows, I am looking for ideas on how I might put side windows on this boat. It has the top rail that goes almost all the way to the back seat. Would windows from another Larson close to the same size fit?
I want to rebuild the floor in my 1996 Larson sei 174, obviously it is a plywood floor, I don't want to replace the carpet when I am finished, I am looking for ideas on how to make the floor look fiber-glassed with a nice finish when it is done and then eventually install snap in carpets. Is...
