The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
i have a 18ft valco bayrunner 1984. i live on the oregon coast and been putting around the bay. I have been hearing that my boat in good weather would do fine in the ocean. i would like to know if anyone knows of some modifications that i could do to make it more sea worthy. transum hight? then...
This motor is 45hp and 74 i think with a outboard jet. san learndo. I see these jets go for big money on other brands of motors. What can u tell me about this jet? is it interchangable on difrent outboard?
Took my 88 seaswirl with 120hp v evinrude. Started right up, idled fine and performed well as far as i can tell. I do have a couple of questiongs. Right below the top cover is an exost. I put my hand over it and it is a little moist. Is that a problem? Aslo the steam of water that comes out, is...
Ok on the picture is a wire that was disconected when i pulled off the cover. Attatched to the wired that is not connected to anything is a white wire with a black strip. I take it the wire was replaced and they attatched it to the new wire so you would know what wire it was according to the...
Ok i drained the gas and put the flushing device on and hooked up the hose. I have never seen this done before so i dont know if it was working properly. Water was spraying out of the sides of the round attatchment. I dont know if it is suposed to do that or if it is supost to grip and fit...
i have just bought a 1988 seaswirl with a 120hp evinrude. I has been sitting for over a year. How do i drain the remander of the fuel with the built in tank? what else should i do? Should i just pay the money and get it drained and tuned up before i take it crabing.
Wanting to know the point gap for a 1975 45hp chrysler outboard? think its the one with the alternater. How important is it to get the gap just right. mod#456hh.
Thanks
