Search results

  1. C

    No Fire

    What are the points supposed to be set at? I keep looking on Google. Trying to figure it out. I can’t get nothing.
  2. C

    No Fire

    1986 2.5 L OMC I have no fire coming out of the Coil wire That goes to the distributor. I have power on both sides of the coil 11.5 V with the ignition switch on I even put a jumper wire from the battery positive to the positive side of the coil wire from the battery and still no fire. I tried...
  3. C

    Stern Drive

    This is a cobra out drive. You don’t feel it from the bottom.
  4. C

    Stern Drive

    Yes, I was going to do that or just take a little bit of oil out and then recheck it. I know I filled it up properly. I took my time took me about 25 minutes to fill it up I would do one pump at a time very slowly
  5. C

    Stern Drive

    The one above the cavitation plate the second hole from the bottom I drained it from the bottom, I put the plug back in unscrewed the second plug screwed in the fitting and pumped it in very very slowly and of course I let the oil drain all the way out of the bottom and it’s just a little bit...
  6. C

    Stern Drive

    1986 omc cobra outdrive I changed the oil I put 64 ounces in it. It’s riding a little high on the dipstick, but I haven’t ran it yet. Should I run it for a few minutes then check it again the Oil level. Thanks to anyone that answers.
  7. C

    1978 Evinrude 115899C 115 hp Outboard Motor …everything is working, but the hydraulics seems...

    1978 Evinrude 115899C 115 hp Outboard Motor …everything is working, but the hydraulics seems like they are locked up. I manually let it down. And then pull it back up by hand. Trying to see if I can get it to move… but still is locked up. Is there a way to unlock the hydraulic pump?
  8. C

    Tilt and trim

    Pull the plug and it was full
  9. C

    Tilt and trim

    1978 Evinrude 115 hp tilt and trim will not go down it will trim up but not down all relays are good motors working good when I stand on the motor and push the button down it will go down but very slowly manual releasing goes down good my question is is there any other way To make the tilt and...
  10. C

    Ignition coils

    Ignition System Parts for 1980 Johnson 85 hp J85TLCSA Outboard Motor What is the difference In these two coils
  11. C

    Carburetors

    Can someone please tell me what’s the difference in a 1978 Evinrude 115 hp carburetor and a 1981 Johnson 115 hp carburetor? because when I look up the carburetor gasket kit on Marine engine the number is the same ? Also will the carburetors work from the 81 to the 78 Because to me both of these...
  12. C

    Powerheads

    I would like to know if the powerheads are the same on a 1981 Johnson 115hp Model number J115TLCIM And a 1979 115 hp Evinrude model number 1158990C And what’s the compression ratio be
  13. C

    No cold start

    Thanks that’s the first time I ever had to use it usually I just start it up appreciate the info
  14. C

    No cold start

    1981 Johnson 115 hp turns over won't start I sprayed some gas in the carburetor ran all day no problems including shutting off and starting back up several times during fishing parked the boat cleaning fish ate and went to sleep woke up the next morning got in the boat would not fire up spray...
  15. C

    Won’t start

    1981 Johnson 115 hp turns over won't start I sprayed some gas in the carburetor ran all day no problems including shutting off and starting back up several times during fishing parked the boat cleaning fish ate and went to sleep woke up the next morning got in the boat would not fire up spray...
  16. C

    blocks

    I have a 1977 85hp and a 1981 115hp johnsons are blocks the same
Top