Search results

  1. J

    94 marnier 60 no start

    Problem resolved. It was the CDI unit. Even though I tested and had spark on the removed plugs, it must have been too weak or intermittent. New CDI block and new plugs and all is well.
  2. J

    94 marnier 60 no start

    Another test. All cylinders 100 compression.
  3. J

    94 marnier 60 no start

    My main engine died yesterday. Here's the story. Ran out to fish ,20 minutes, no issues. Trolled around on the 9.9 kicker. Time to come home cranked the main. It started ran about 5 seconds stopped. Not unusual. I gave it bit of idle and cranked again. It just cranked and cranked, no start. I...
  4. J

    1995 mariner 60 lower leg

    1995 Mariner 60HP outboard. Is it possible to remove the lower leg and leave the power head attached? I have a cooling system leak at the top of the leg and am trying to avoid lifting the whole power head off. There is a 2" spacer between the power head and the leg that the steering is attached...
  5. J

    gear case lube

    What is the lube that should be used in the lower end of a 1995 mariner 60 and 9.9? Is it just sae 90 gear oil like I would use in any gear case? The Quicksilver page show 80w90 for below 75 hp.
  6. J

    Mariner 9.9 tubing question

    Where does the hose at left arrow attach? The other end goes into a T at the arrow below. The T goes up (into carb I think) and over to the other down arrow on the block. The hose was laying in the bottom. The end of the hose is not expanded as if it was on fitting so I think maybe it just lays...
  7. J

    60 Mariner slows to idle while cruising

    1995 60 HP mariner 3 cylinder 4 stroke. The issue. While cruising to my fishing spot at about 3800-4000 RPM, 18 MPH the engine will suddenly start slowing as if I pulled the throttle back. I jam it forward full throttle and takes off. I can keep it running fairly well by working the throttle up...
  8. J

    next page of posts

    What happened to the link at the bottom of the page to move to the next page of posts within a forum? When you are scrolling through a forum and get to the bottom you have scroll back to the top to get the link for page 2. It used to be at the bottom and seems more useful that way.
  9. J

    unread threads reset

    I came to the site today and had to log in. Must have cleared cookies or something. The problem is even though I not been here since yesterday all the threads are marked as read, even stuff that happened 2 hours ago. I have seen this happen before. It seems if you come here not logged in and...
  10. J

    choke function/operation question

    My understanding of how the choke works. You press in the key and it closes the choke flap. You continue to hold it in while you crank the engine. Let go as it starts. What someone is telling me it does. You press in the key and the choke closes the flap AND it shoots gas into the carb as long...
  11. J

    Battery switch

    I am looking to install an A/B battery switch in my boat. Looking for recommendations for brands to use or stay away from.
  12. J

    unread posts

    I couldn't find help or suggestion section so I will post this here. I have a problem with how the unread posts function works. first problem. It resets too soon. If I go away for 5 or 10 minutes to review a link or something it resets. I think the time should be longer like 30 minutes or even...
  13. J

    mariner 60 air box to carb gasket

    How important are the rubber ring gaskets on the air box? I noticed that two of them were missing when I went to replace the air box. What do I call this part when looking in the parts manuals? I can find carburetors but not the air box. Motor is a 1995 mariner 60 ser OG211531.
  14. J

    oil line from tank

    1995 60 HP mariner 3 cylinder. The oil line from the tank to the pump is dried and cracking. Is there any special TYPE of line I need to get or will any plastic tubing the same diameter be fine? The stuff that's there now just looks like a stiff plastic tubing like the type I used to use on my...
  15. J

    Microsoft computer scam

    Don't fall for this scam. There is no way they can know you have a problem. I got one of these calls tonight and kept them on the line for ten minutes before they hung up. Yep they hung up not me. First I made them wait 5 minutes while I booted up my PC. It was already on. Then they ask me to...
  16. J

    iboats very slow loading

    Is anyone else experiencing slow loading of iboats? It seems to take 30 seconds or more to load a page on this site. Any other site I visit loads in less than 5 seconds. I can skip through 4 or 5 pages on another site while iboats is loading one page. Tried on both FireFox an IE8.
  17. J

    tilt relay part number needed for 95 mariner 60

    Looking for the part number for the tilt relay. When I put my serial into parts express it shows the pump and ram assy but I don't see the two relays. After market parts is fine with me as well but need the original part# to confirm replacement. Relay itself is HELLA 4rd 960388-32 Serial #...
  18. J

    mariner tank pickup tube

    Trying to find the tank pickup tube for inside the portable fuel tank. Went to dealer and he kept trying to sell me new tank. Nothing wrong with the tank or external fuel lines. But the internal pickup tube rotted off. I looked around Iboats but only external fuel parts can be found.
  19. J

    charging output amps

    What is a charging output in amps of my 1995 Mariner 60Hp 3 cylinder ser OG21531? Thanks
  20. J

    Spammer PMs

    What is the procedure for reporting spammer PMs. I received one today from Valerymip. I still have it if anyone wants it forwarded.
Top