Search results

  1. C

    Engine with jack plate height questions

    Wondering if this would cause my johnson gt 150 to take around 10 seconds to get on plane? Motor is mounted on a 5 inch jack plate, and has a step in the hull. Center prop shaft is about 6 inches below hull and the plate is about inch and half above. Should I raise it an inch?
  2. C

    Need recirculating valve diagram 1988 Johnson gt 150

    I'm not sure if the hoses where replaced in the correct places for the recirculating valves on my 1988 johnson gt 150. Does anyone have a diagram, my manual does not.
  3. C

    Johnson j150stlcca with air leak in crankcase

    I have a 1988 johnson gt 150 that that has been running a little lean and ruff at idle. Also when i accelerate it takes a while to plane ( 8sec on 17ft bass boat) and wot is around 4400 rpms. So today i checked for leaks. I took a soapy sudsy solution around everything to check for leaks. The...
  4. C

    1988 johnson gt 150 problems possible carburetor issue

    I had many little issues I've tried to nip, now there's another. I'll start with what I've done. Had a spark not firing, so replaced coil, now works. Had leaking fuel lines, replaced them all. Cleaned carbs and put new kit on them as well as a link and sink. Replaced regulator, rectifier...
  5. C

    1988 Johnson gt 150 with low hp output

    I have a 1988 johnson gt 150 on a 1989 nitro 1800tf (17ftbass boat). The idle is a little low but it sounds like it runs good through all rpm ranges. I have tried 2 props. First one is a 14 1/2 24p raker. When I throttle , i hear the the engine rev up nice and fast, but the rpms on the tach...
Top