Search results

  1. F

    9.5 9222M Gas supply problem

    Motor runs fine if I use bulb pump to supply gas. If not then motor runs until bowl empty. Person that I purchased from told me he had this problem and had replaced gas pump. Is there something else that may be causing this? Or is the gas pump the problem? Filter in gas pump is clean. Thanks---Gregg
  2. F

    Evinrude 9.5 Slow speed cable

    I am looking for directions on how you install this slow speed cable that runs from the control knob (rotary knob) at the tiller base to the carb. I cannot see where this enters into the engine compartment. Do you have to take the handle off? Or exactly how is this installed. I bought this motor...
  3. F

    9.5 HP Evinrude start position

    Model 9222M. Cannot get to start position on tiller handle unless I put in forward gear? Motor manual says to advance speed control and the motor will sart but must be in gear to make this advance. Can you not start this motor unless in gear? Also have small coil spring behind in this area that...
  4. F

    1940 Evinrude 4355 3.3 HP parts list or manual

    Hello--- looking to obtain a parts list for an Evinrude 4355, 3.3 hp.
  5. F

    How to change carrying handle in 1951 Evinrude 7.5 hp?

    Good Morning--- I need to change out a broken steering handle on a 1951 Evinrude 7.5 hp motor. Can someone provide detailed instruction on how that is done or provide infomation as to where I can find out how this is done. I have been told that the power head must be removed to do this. If so...
  6. F

    1951 Evinrude 7.5 Hp questions

    Hello-- a couple of questions for the experts on this forum: 1.) Was is the recommended torque for the bolt that hold the fly wheel over the coils? 2.) What is the process to remove the handle located under the tiller -- mine is broken an I am planning on replacing it? 3.) How do you tell if...
  7. F

    How to Change water implller in 1951 Evinrude Lightwin 7.5 Hp

    Hello-- need input on how to inpect,or change water pump impller in 1951 Evinrude lightwin. Have dropped bottom section off that hold horzonital propeller shaft. Now have drive shaft exposed. Where is the impeller located and how do I get to it? IS there any other screws that need to be removd...
  8. F

    Request for Evinrude Lightwin 1951 7.5 Hp manual (series 4443)

    Good afternoon-- looking to see if anyone has a parts manual for Lightwin 7.5HP 1951 year model 4443 ? Had seen some previous posts and had requested info but they were old posts (2006- 2007) so those people may no longer be viewing this site. Would like to obtain acopy withot the $38-$50 cost...
Top