Search results

  1. B

    bravo III upper rebuild

    Drive #OW930932 I am rebuilding a bravo three upper with new gears. I've done bravo ones a few times and an older bravo three but this one is different. I have two questions: 1)There is no stamp on the drive telling me what shims (thrust races) to use, should I stick with what was there even...
  2. B

    Just looking for Trigger/Stator ohms specs for my merc

    I have a OT628246 merc 90hp 3 cyl. I have an older manual and was wondering if the readings of the triggers and the stator are still the same. The older manual reads 1100-1400 for the trigger resistances. The stator test says Blue and Red 3600-4200 (90-140) I'm not sure why there are numbers...
  3. B

    Drill through an acrylic deck hatch

    I have a low profile lewmar hatch #2678365 made of acrylic. I'm looking to install a solar powered vent on it but to do so I would have to use a hole saw and drill some attaching screws. Is drill through acrylic something that can be done? Putting the vent anywhere else isn't an option...
  4. B

    Small spacer with new upper drive bearing set

    Doing a reseal on an alpha gen ii upper and replacing the bearings on the drive gear as well as shimming (I have all the tools/book etc...). I'm replacing the bearings because they were rusted and you could easily feel it as you spun them. The new set of bearings came with an extra small...
  5. B

    Spindle nut too loose or too tight?

    I'm replacing the bearing for the wheels on my trailer (both the inner bearing and the outer bearings) and I have a question about the tightness of the adjusting nut. I have the 1-1/16" tapered spindle. One side is fine but the other side is either way too tight or loose enough for me to be...
  6. B

    Volvo Penta 5.0gxi-f water pump question

    I have a Volvo Penta 5.0gxi-f with raw water pump #3812519 (new number I think is 21212799). Is there a part number for the seal behind the impeller or if that goes bad does the whole thing need to be replaced? By seal I don't mean the o-ring for the housing I mean the seal that goes around...
  7. B

    Mercruiser net lash?

    I'm doing the valves on a mercruiser mpi with the roller style rockers. I went to look in the book #32 and it just says to adjust valve clearance. I look in the specification section and it says "Net lash, no adjustment." I'm not really sure what that means, do I just torque them to...
Top