Search results

  1. T

    Motor guide trolling motor

    Need diagram for trolling motor foot switch with a 5 speed dial that has only high speed
  2. T

    1982 Johnson 140hp

    Hi folks
  3. T

    1982 Johnson 140hp

    I honed cylinder put everything back together but don’t have my lower unit it’s at lake was wondering can I connect water hose to the water tube and start motor without lower unit thanks for any replys
  4. T

    02 mercury no plane

    Trying to help a friend 02 mercury 200hp efi will not plane out compression within 5 psi of 120 new plugs he took to mechanic he said must be ecu he said fuel pump would go up to 45psi when reved I checked just psi with gauge in fuel line only it was 38 psi he ran out of fuel before this problem...
  5. T

    200 efi

    My friend has a mercury 200 efi 02 model was on plane it just died wouldn’t start back got it back trolled then next day top plug was carbon up some but it will start but in water won’t plane off some people say crank shaft sensor if not the computer any ideas i not familiar with mercury but I...
  6. T

    1982 pt&t Johnson 140

    I have a pt&t motor three wire would someone explain the circuit inside the motor thanks for your help
  7. T

    79 Johnson tilt and trim

    My friend has a 79 140 Johnson and the power tilt and trim stopped working the motor runs fine but it will not raise the motor or lower the motor we can use the bypass screw to raise it and lower any help would be greatly appreciated
  8. T

    115 mercury

    My friend has a 1989 mercury 115 carburetor motor with no spark to top plug 4 cylinder I was wondering if you could tell me what the power pack is called on a mercury stator wires go to it coil wires go to it I need to get an approximate price so I can tell him thanks for your help
  9. T

    1996 Evenrude 90hp

    I’m trying to get the torque spec for voltage regulator thanks for any help
  10. T

    V-4 cylinders

    Would it be advisable to bevel the exhaust and intake ports in a cross flow motor thanks for any response
  11. T

    V-4 Johnson 140 hp

    If you tear a motor like this and replace a piston do you have to re- time the motor after u put it back together
  12. T

    johnson 140 hp

    do anyone know if j140tl79 have limp mode or not young friend says his is going in limp mode 2500 rpms or so i dont think it has that function thank you for any help
  13. T

    05 Johnson

    I am looking at a 05 Johnson 90hp j90Glsrm like to know if anyone has info or good or bad things to say about the motor I understand there are checks to be made but just about the motor in general
  14. T

    Checking stator

    Can someone tell me the ohmns reading for 1983 140 hp 6 amp battery charging part of the stator my service manual is at home and I am at Douglas lake fishing
  15. T

    05 sun tracker

    new to pontoons when i put my cover on for winter it gets mold on seats can this be prevented thanks for any help
  16. T

    97 johnson 150hp

    advice on 150 fast strike 97 johnson are known to be good motors i know it depends on care of owners but any weak points to watch out for for instance i found out my 83 crossflow has bad ring / piston design just good points and bad thank you for any responce
  17. T

    tahatsu /mercury

    i read somewhere that tahatsu makes mercury and some other brands is this correct
  18. T

    1982 140hp cylinders

    Do you see anything that makes this block junk
  19. T

    83 johnson 140 controls

    my forward / reverse controller is mounted with 2 long phillips head screws with nuts on the inside of wall very hard to reach behind there to hold nuts to start screws anyone know how to fix this problem thanks for any help
  20. T

    82 johnson 140

    seems to me most v-4 johnsons has ring failure on # 4 cylinder anyone have ideas why? is there a way to help prevent it thanks for your responces
Top