Search results

  1. S

    04 Yamaha 0x66 200 v6 overheat light

    I have a 2004 0x66 200. When I start the engine cold, the overheat light comes on and stays on with no alarm sound. Water is flowing through normally. Is this just a bad sensor or is this some type of code (like a check engine light) saying something is wrong?
  2. S

    Anit syphon valve removal

    I am tyring to remove an aluminum syphon valve and pick up tube that the fuel line broke off of on an internal gas tank. Any suggestons on what my options are if I can not get the pick up tube to unscrew from the tank without breaking it. I have tried everything from an impact gun to a pipe...
  3. S

    Primer bulb wont prime after losing suction from internal tank

    Lost suction of fuel while trying to drain water out of 22ft bay boat by getting on plane. Boat was heavy in rear and engine died when the bow was very high trying to get up to drain with plug out. Had to tow back to dock and still can not get bulb to prime. Newer primer bulb and lines.
  4. S

    Misfire 2004 200yamaha v6 ox66

    Engine is misfiring. Has rough idle not running on all cylinders. I have changed plugs and checked for arching on plug wires. I found some arching on one of the plug wires. I was told by the dealer that genreally the put a rubber sheath around the plug wire to fix because the plug wire is part...
  5. S

    tilt and trim

    I have a 22 ft bay boat and the tilt (up) does not work from the bow switch or the switch on the throtle. Down works fine from either. However, the switch on the engine (Yamaha 0x66 200) works up and down. Any suggestions?
  6. S

    lower unit "clinck" going from drive or reverse to neutral

    I here a noise that is not mormal for my engine. When I shift from drive to neutral, I here a loud "clinck" noise from the gear area. It sounds like something is loose. Is this a maintenance item or am I looking at a big repair?
Top