Search results

  1. S

    Tohatsu MFS 60 reset oil light

    Any one have any insight on how to reset the 100 hour oil light that blinks on the tachometer for a 2020 Tohatsu MFS 60 ? I've tried following the procedure in the manual several times with no luck . Tried doing it with a timer also turn key on wait for the beep to finish pull lanyard...
  2. S

    50-1 Mix in a new 4 stroke

    I just upgraded to a new Tohatsu mfs 60 and still had several gallons of some pre mix 50-1 gas in the integrated tank on my boat. The dealer is telling me not a problem to leave it in there and run it through and switch over to straight gas . This is a brand new motor that needs to be...
  3. S

    Drops of gear oil Johnson 70 TLESB

    I'm seeing a few drops of gear oil coming from this weep hole only when i have the motor tilted up. It smells and feels like gear oil , its not residual gas / oil. Is this anything i should be concerned about ? I haven't changed the gear oil since spring so i'm not sure if water is getting...
  4. S

    Tohatsu MFS 60

    Was recently pricing 60 HP outboards across the board, and was wondering about the reliability of the Tohatsu motors . I don't see alot of these motors in my area but i've never heard any negative reviews about them . Do they have any weak points about them ?
  5. S

    Johnson 70 HP TLESB Flywheel Removal

    I'm trying to remove the fly wheel on my Johnson 70 HP model TLESB so i can replace the stator , I've removed the nut but cant seem to get the fly wheel off . I have a 24" breaker bar and a strap wrench on the fly wheel to hold it but it just wont budge . Are there any tricks out there to get...
  6. S

    Johnson 70 HP TLESB spark on only 1 cylinder

    I've been trouble shooting different ignition parts on my Johnson 70 model TLESB , it went from running good to a no spark situation on 2 cylinders. The ignition coils are 1-2 years old and check out good with the ohm meter , my power pack is about 3 years old , i haven't checked that yet ...
  7. S

    Air Silencer to Carb gasket

    Is it possible to use permatex gasket maker where the carburetor and the air silencer meet ? Any draw backs to this ? Permatex has a sealant for 2 stroke motors , it appears like it might be OK ?
  8. S

    Keel repair for a 16' open bow

    I have a 16' open bow Wahoo that i purchased about a year ago and the keel is worn out to the fiberglass , what would be a good product to repair this area.? I've been using the boat regularly and there's no leaks in the hull, its a solid boat . The area that's needing the repair is about...
  9. S

    1990 Johnson 70 HP warning horn

    Are there any side effects of disconnecting the warning horn at the remote control, i had a short (bare spot ) on one of the wires that feed the horn so iv'e disconnected it .
  10. S

    1990 Johnson 70 HP manual tilt & trim

    I'm installing a manual tilt and trim assembly on a 1990 70 HP Johnson model TLES and looking for any pictures of how to install the Lever and Shaft part # 397730, all the parts diagrams i'm finding dont show enough . Any help would be great. Thanks !
Top