Search results

  1. C

    Starting an 57 Evinrude 7.5 fleet win after many many years of storage.

    seee reply on double posting to AOMCI
  2. C

    1971 Johnson 25hp Outboard - 25R71S

    you either invest in the real McCoy OEM puller $$$$ or just go simple harmonic puller $$ which will do the job see mine with inverted nylon nuts to prevent going to deep in the FW and hitting coils lots of utubes on refurbishing standard OMC magnetos. when do adjust timing. may...
  3. C

    1971 Johnson 25hp Outboard - 25R71S

    you sould pull the fw anyway to check coils...easy fix if all cracked like picture change plug wires and boots to ! capacitors likely dead pointscan be "touched up" for a test refurbish which you should do runs about $150 in parts coils... points,,, capacitors,,,, carb kit ,,,4 feet of...
  4. C

    Leroy'S R.I.P. ???

    correction for Rollerball movie buffs .... it was the13th century Yes, you read that right. The librarian just dismissed the WHOLE OF THE 13th CENTURY that just disappeared from archival existence. That “Just Dante and a few corrupt popes” amount to “not much.” So I’m pausing in the middle of...
  5. C

    Leroy'S R.I.P. ???

    they did not reply to my email * leeroy@leeroysramblings.com Reason: There was an error delivering your message to leeroy@leeroysramblings.com. The server responded with "550" - "550 No Such User Here\r\n"
  6. C

    Leroy'S R.I.P. ???

    Leroy’s Site seems taken over …. anyone know where the original and precious contents went to ??? I wrote to the new Leroy….. asking where all the good OB stuff ended up. Hopefully not just turfed out like the 17th century in Rollerball !
  7. C

    battery charging issue has me stumped

    I am not suggesting you zap things at 130v... that is for Telcos only clearing oxyde on cable pairs ...if that is what you had in mind !
  8. C

    Evinrude outboard year

    post picture of the plate cleaned up
  9. C

    battery charging issue has me stumped

    All good suggestions yet OP said 0 ohms measured from rectifier output to batery end of the cable . I asked several time to clean all connection points ....across the solenoid In telcos whenever we had green death on cable pairs joints/splices a good shot of DC 130v fromthe CO. would...
  10. C

    battery charging issue has me stumped

    here is another option ... remove rect/reg . test stator specs for your engine if stator ok and generates AC hook up the stator AC source to cheap amazon full wave rectifier direct connect the Amazon unit to the battery and check for volts going up with rpms if your's is a 3 phase...
  11. C

    battery charging issue has me stumped

    check your VOM most can handle 10 amps dc curent unless your's is a small .. very basic version .
  12. C

    What starter gear?

    here is one option... parts look-up for a 1980 25hp electric start shows..... 11.... :)
  13. C

    1978 Johnson 85ML78C

    I do not have a blaster unfortunately and althought I do agree on the potential of rendering a plug useless I have across 50+ years ...done so with no apparent ill effects by simply not being overly agressive on the plugs. A small SS brush works to.... followed up with a wash of...
  14. C

    battery charging issue has me stumped

    yet at several posts OP says battery charges up fine, runs the starter fine and no apparent "voltage change" when hooked up to a different battery (lawn tractor battery) well in theory with RPMs current/volts should flow out of the stator/rectifier and to eliminate the battery " option"...
  15. C

    battery charging issue has me stumped

    by ohms law the disconnected end of the batt cable will be the highest resistance point of the cct so it is normal to see vols maybe not amps but volts only ! with the batt connected the highest resistive point is no longer the open air cable end work back to the solenoid and back to...
  16. C

    E10RCNS 9.9 1982 evinrude lower unit seal kit

    don't forget 15% GST and Prov. taxes here it adds up to $190 hr. asking competitors to agree on raise prices also known as collusion....:-( aka price fixing. one local shop wanted $375 (plus 15% taxes) for fixing 2 inches of broken keel ... JB weld $10 not perfect but ETEC blue will...
  17. C

    E10RCNS 9.9 1982 evinrude lower unit seal kit

    ? sorry no pics
  18. C

    battery charging issue has me stumped

    how is the weather ?
  19. C

    1978 Johnson 85ML78C

    well those plugs could still work.. just polish them up on a wire wheel and carb cleaner , gap them reinstall them and get rid of the big anchor asap....
  20. C

    Revolution limiter

    mdl# hp?? manuf ? ficht ?
Top