Search results

  1. C

    AMS Oil 75W90 or Evinrude Lower Unit Gear Oil

    Wally mart marine gear oil ....should be fine.
  2. C

    1957 Johnson Rd-19 35hp questions

    see also .. http://nymarine.ca/cowlgaskets.htm black 25-30-35hp (RD) 1955-58 5ft $69.00 304018 304018
  3. C

    Low Charging, possibly incorrect wiring?

    rectifiers for simple testing AC to DC can be these ... AC in DC out easy to mount high amp capacity but...no regulation . can't beat $3.00 each...
  4. C

    1998 Johnson 175 Ficht Not Starting

    read up on this trouble case from the ETEC world..... https://www.etecownersgroup.com/post/intermittent-injector-pause-during-diagnostic-injector-test-12224332?highlight=noid%20lamp&trail=30 the fellow who purchased NOID lamps referred to cheap ones from AMAZON... never used them myslef but...
  5. C

    1957 Johnson Rd-19 35hp questions

    i have used car door edge trim...come in diff.sizes on Amazon some use fuel line sliced down the middle and glue on. "Goop" works pretty good
  6. C

    1968 Johnson FD-16A

    since ou will replace cracked oils ( many utubes on the subject) you can measure the new ones between the HV pin and either short primary wires and expect 4-8 KILO ohms approx.. primary to primary short wires is about 1 ohm or less as Racerone said... don't even bother with the...
  7. C

    Low Charging, possibly incorrect wiring?

    2 yellows (AC) normal go to the rectifier to become DC or regulated DC if you have a rectifier-regulator to give you flat DC
  8. C

    1968 Johnson FD-16A

    probabaly true... unless it is just sucking up the remaining fuel in the upper chamber but you can check the center post HS throttle tube and side aeration holes if yours has any. they help vaporize fuel. check the fat donut at the base pump the bulb to ensure the carb bowl is...
  9. C

    1998 Johnson 175 Ficht Not Starting

    injectors and coils on FICHT and ETECs are fired by ground pulses on individual control wires (see diagram) that carry the common buss operating voltage looped back to the ECU /EMM via the internal coils of each component to trigger. this is how fault codes on open injectors and coils...
  10. C

    1998 Johnson 175 Ficht Not Starting

    a diode by itself is just a one way check valve resistance measured one way is very low read the other direction it is very high... do utbe searches on testing diodes ... simple devices
  11. C

    No shut off

    ground the power pack kill wire(s) if no effect power pack is defective if engine dies... back track and find the missing ground back to the key
  12. C

    No shut off

    with key OFF engine idling wiggle twist turn all wires or cable you can access. IF the engine reacts (Dies) inspect wiring closely for a break.
  13. C

    1968 Johnson FD-16A

    well the bottom needle (HS) can be seated gently then openned 3/4 turn and the top LS needle 1.5 turns out for trial. adjust later as per manual what is important in starting is that the crankcase vacum must pull fuel from the upper fuel route (LS) needle into that small drip chamber...
  14. C

    1957 Johnson Rd-19 35hp questions

    what ever travel direction is shortest and easiest to access
  15. C

    1957 Johnson Rd-19 35hp questions

    if you can have an exact diam. tube maybe you can guide it over the stuck of tubing and hammer out the broken part dowwards. apply a release agent if possible to help things slide out. if you have reasonable access where it is broken you could try freezing the joint with a can of...
  16. C

    1987 Evinrude XP 150, Leaking black oil from midsection????

    best not to revive 8 year old posts... start a new one ... site policy
  17. C

    1973 4hp Evinrude

    pictures don't work (post) here anymore. gouges can be filled with JB weld and sanded smooth like metal. the gasket will protect it when installed properly
  18. C

    1992 Evinrude 150 aluminum in cylinder

    no sense in beating a dead horse but very unfortunate those things (easy to check) were not done before the sale. If the seller would have balked then you run away ...measured compression on 5 other cyl wasn't to good anyway.
  19. C

    1993 Johnson 4hp deluxe

    you should have no problems finding 0767407 - Impeller Assembly parts look-up shows a small 3 blade impeller starting with the 1993 models lots of utubes on changing impellers
  20. C

    2000 - 225 Evinrude Fitch EMM Question

    I can only go by that write up from GEB our expert on the ETEC board and he indicates it will work on FICHT engines. Up to do to roll the dices Some EV diag come with a CD ...like mine.... some come with USB pick what is best . Choose the one with the FDTI chip adapter to convert the PC...
Top