Search results

  1. pvanv

    2020 tohatsu adding electric start

    No kits. You need the starter, solenoid, switch, and wiring. Usually not cost effective.
  2. pvanv

    NS5b water pump

    Normal.
  3. pvanv

    Nissan 9.9 2 stroke stuck lower unit

    Wedges and patience.
  4. pvanv

    compression 40 psi after changing head gasket tohatsu

    Yes. Euro version 2 cylinder. No decompressor. Should have higher compression.
  5. pvanv

    Nissan 9.9 2 stroke stuck lower unit

    Likely the driveshaft is stuck in the crankshaft.
  6. pvanv

    Tohatsu. 2.5hp 4 stroke lower unit jammed

    Sounds like shifter is mis adjusted.
  7. pvanv

    Engine cutting off

    Probably a bad o-ring in the primer hose.
  8. pvanv

    Power tilt fluid refill

    use ATF. Fill while tilted and then cycle it and then refill.
  9. pvanv

    2002/2003 NSD70A2 Nissan 70HP TLDI remote control / console gauge wiring question

    Whip out your Factory service manual and the owners manual for help.
  10. pvanv

    Break in oil

    Yep. Use NMMA rated FC-W 10w-30. Verify 1/2 way on dipstick.
  11. pvanv

    Tohatsu throttle problem

    I would definitely check inside the carb.
  12. pvanv

    Tohatsu throttle problem

    Model 9.8A3? Is it so rich that the full throttle gives it enough air to run? What do the plugs look like?
  13. pvanv

    Nissan 9.9 help

    Ugh. Round float carb, or octagon float? Sounds like flooding. Some individual parts are still available. I would verify float height first.
  14. pvanv

    2.5HP Mercury/Tohatsu/Nissan Outboard No Longer Starting

    I would move the clip down, to raise the needle.
  15. pvanv

    4 HP Nissan Flushing Plug

    Any Tohatsu/Nissan/Mercury/Evinrude dealer.
  16. pvanv

    ns50c timing specs

    If you didn't change them, they should still be correct. I don't know the numbers off hand, but I think that stuff is in your manual.
  17. pvanv

    70hp tohatsu running rough

    I vote for a proper carb cleaning.
  18. pvanv

    2.5HP Mercury/Tohatsu/Nissan Outboard No Longer Starting

    There are 3 settings for the needle. Depends on where you install the clip. Also a screw to set idle.
Top