Search results

  1. C

    Low voltage to fuel pump relay

    I think the wiring diagram that Bruce58 posted is for a carbureted motor, it would have one pump. The OP Leedanger stated they have the 5.7 GSi PWTR, which would have the fuel injected TBI system with the two pumps. The ECM controls the pumps, I believe the relay should have constant 12v.
  2. C

    Idler Pulley Part #

    Hope it works out for you.
  3. C

    Idler Pulley Part #

    See if something matches what you have, Dayco pulleys
  4. C

    Sx-m trim cylinder loose

    The plastic bushing is to be inserted in the outdrive housing, not the trim cylinder.
  5. C

    Volvo Penta DP-SM water pickup fitting

    It is a drain hole, no o-ring in that groove and pointing down. VP states that if this hole is blocked it could prevent water from draining out when you winterize your boat and could cause damage from freezing.
  6. C

    Mercruiser 470 Starter

    Verify fitment Starter
  7. C

    94 5.0Fi HU high pressure fuel pump re-assembly

    That is the correct location of the o-rings but do not reuse the o-ring next to the threads. That o-ring has taken a shape and you can see the tearing of the material. When you reassemble, lubricate both o-rings with motor oil and put the second o-ring on after you put the bolt through the housing.
  8. C

    Need help identifying weird oil plug

    Google "oil dipstick tube block off plug"
  9. C

    Removing impeller

    Blow up your picture and you will see the part number on the impeller.
  10. C

    Removing impeller

    The threads on the impeller is a possible clue, You may need a 1/2 x 20, 9/16 x18 bolt or a specialty tool to match the threads to press the impeller off of the shaft. Also don't loose the little o-ring that's stuck in the screw hole.
  11. C

    speedo gauge wrapped around.

    Probably there is water in the bourdon tube inside the gauge, the water must have froze and expanded the bourdon tube and cause the gauge to wrap around.
  12. C

    VST question for 5.7L TBI....

    Yes, That is the fitting you are looking for.. Yes, That is what hose A should be connected too. Hose B is most likely the cooling line coming off the starboard side of the VST tank, there is another line coming off the tank on the port side and should be going to the port elbow. That is why I...
  13. C

    VST question for 5.7L TBI....

    Look under the starboard side of the throttle body assembly, there should be a device called an impulse limiter part # 3852225 screwed into the side of the intake manifold with a 45 degree elbow. This is where Volvo Penta connects the vapor hose from the barb fitting on the VST. Make sure you...
  14. C

    Trailering tragedy

    http://www.silive.com/news/index.ssf/2015/09/sources_1_cyclist_dead_another.html#incart_2box_silive-homepage-featured
Top