Search results

  1. muskyfins

    Need Ideas for Boat Mooring

    You might be able to tie up stern in. With two good spring lines and 5 bumpers, it might work. It would be similar to below. This is shown with a 6 foot pier, 10 foot wide slip, and a 21 foot boat. Red is dock lines and purple are bumpers.
  2. muskyfins

    Can I start/charge my deep cycle from the alternator?

    I have opened a can of worms on this battery thing, but this is a separate question. If I'm on the hook for a couple of hours, can I start up the motor and charge up the deep cycle house battery? I guess I've seen where folks say this is a bad idea. I suppose I could get a dual purpose...
  3. muskyfins

    House battery sizing and discharge rate

    I know there is a way to calculate how long my house battery will power my electronics while on the hook, but can't quite remember the formulas. I'm adding small amp to the stereo this year, so with that running half total power output, I'm expecting somewhere around 40-50 amps total draw. We...
  4. muskyfins

    You're doing it wrong.....

    especially if this happens....
  5. muskyfins

    Fishing line quick connects?

    I have purchased bulk snap lock connectors for my 3 ways in the past with some level of success. Doesn't work too good for fish that spook easily like some bass and walleye, but muskies couldn't care less.
  6. muskyfins

    Propeller Giveaway

    And as for more pictures, got a sneak shot of the admiral. and one of our son with my namesake fish
  7. muskyfins

    Adding amp. Use buss bar?

    kinda like this. battery switch not shown.
  8. muskyfins

    Adding amp. Use buss bar?

    The first column on the chart is circuit length and the chart is set up for 3% drop or less, so 6 gauge should work fine. Yes, circuit breaker. Forgot to mention it. But why run straight to the amp? The panel in the link from my first post is intended as a distribution block. The wiring...
  9. muskyfins

    Adding amp. Use buss bar?

    Planning on adding a stereo amp with a 40 amp built in fuse. I suck at electrical ,but peak output power is 94 watts x 4 channels, so 376 watts/12.5= 30 amp draw. Sound right? Ok, then per the following chart, and about a 20 foot run from the battery switch to distribution block, I need to...
  10. muskyfins

    Propeller Giveaway

    That is one sexy wood propeller. In for contest with photo below.
  11. muskyfins

    I want to build a smoker, question..

    Supplies Inside of unit after assembly. (about 40 minutes) In use during seasoning.
  12. muskyfins

    I want to build a smoker, question..

    Test photo. Worked. Very weird. If I transfer these photos from my phone to my computer, they will not upload to iBoats. If I email them to myself and use my PC to open and save them, they work just fine. Phone is Samsung GS4. Any Ideas? Anyway, this is pic of unit during seasoning. I'm...
  13. muskyfins

    House electrical

    My 1995 Rinker has shore power. And an electrical panel. Does this panel only control the 110 volt? For example, yesterday, the refrigerator was running from 12 VDC. But on the panel, the switch was off. This leads me to believe the panel only controls the 110 VAC side. Just looking for...
  14. muskyfins

    Abu Garcia Giveaway

    Well, anyway, here's a picture of the admiral getting started on dinner.......
  15. muskyfins

    How long is a post editable?

    I have a knack for not being clear, so sometimes I feel the need to go back and edit posts. How long are they editable?
  16. muskyfins

    Have you ever broken a gimbal ring by overtightening???

    I have a thread on here regarding the worn gimbal ring issue on my Bravo outdrive and possible fixes. I have done a lot of internet research and some folks say you can over tighten and break the ring. (even below the 53 foot pound torque spec set by Mercruiser) I can't really see it breaking...
  17. muskyfins

    wrong prop for drive?

    I would tend to believe this also except if you look at post #21, in the pic, it is clearly a B1 upper:frusty: At this point, if it's solid and I can achieve correct WOT rpm range without over taxing the motor, I'm going to have to let this go. I have to address this stupid gimbal issue...
  18. muskyfins

    wrong prop for drive?

    I guess I'll throw in the pic of the engraving on the side. This is just forward of the serial number. Little tough to see, but it is printed "220R"
  19. muskyfins

    wrong prop for drive?

    The only reason I refer to this as a Bravo 1 upper is that was its original intent. (see picture) I did not realize there was no difference between a right and left rotation, but AllDodge's explanation makes total sense. Thanks. Still not sure what the 220R means? Is gear ratio defined in...
  20. muskyfins

    Worn gimbal ring issue

    While starting planning for this year's boat fixes, I came across the dreaded worn gimbal ring to steering arm shaft issue on my Bravo outdrive. Notably, the square steel shaft, wears the square bore in the aluminum gimbal ring. I haven't taken the time to measure the amount of play or size of...
Top