Search results

  1. topgun3690

    Random

  2. topgun3690

    Gun ownership and permits.

    Bottom line........"A gun in hand is better than a cop on the phone."
  3. topgun3690

    Most common problems with 4 cyl / 3cyl chrysler outboards

    Best to have engine all the way down when trailering, if possible. If not, support it with a transom saver or similar. With it tilted up and not supported, it puts a lot of fore and aft flexing on the transom.
  4. topgun3690

    1990 Dual Force 120s one side showing 16.7v at speed with dual batteries

    I mounted the new VR in the same spot as the original rectifier.....which is on the starter bracket which is out away from the engine block, so not directly in contact with the block heat.....which really doesn't get that hot anyway. Not sure how the rectifier on your Force 120 is mounted but...
  5. topgun3690

    Cleaning drain passages

    It would crack it big time.....good thing you got it cleared out so it drains properly. (y)
  6. topgun3690

    1990 Dual Force 120s one side showing 16.7v at speed with dual batteries

    I used one of these on mine. Has worked very well at taming the high voltages I was getting. Less than $40...... https://www.mfgsupply.com/snowmobile/snowel/snowregs/01-090-1.html
  7. topgun3690

    Parking boat in driveway

    Next they will put you on "Double Secret Probation".....
  8. topgun3690

    1976 Chrysler/Force 6hp 2 stroke where to get new parts, manuals,etc.

    That is a parts catalog......it could be useful but it is not a shop manual, got to look at the description carefully. (y)
  9. topgun3690

    Floor in houseboat

  10. topgun3690

    1976 Chrysler/Force 6hp 2 stroke where to get new parts, manuals,etc.

    The factory manuals are year specific. If you can't find one for a 1976, you may be able to use one for a 1975 or 1977....maybe @jerryjerry05 or somebody could verify what years would be good to use for your 1976 if you can't find one.
  11. topgun3690

    1976 Chrysler/Force 6hp 2 stroke where to get new parts, manuals,etc.

    The best SHOP manuals are the ones published by the engine manufacturer. An OWNERS manual will have little if any useful info for doing repairs. The generic manuals, like Clymer and Seloc try to cover too many models/years and leave a lot to be desired. Ebay is a good source for used factory...
  12. topgun3690

    1976 Chrysler/Force 6hp 2 stroke where to get new parts, manuals,etc.

    Just looked on marinengine.com for 1976 6HP (63HH).....they have the impeller, housing, and other parts in stock. For parts NLA use their part numbers and look on ebay. Also, Crowley marine, boats.net, Franz marine, MasterTech, etc.... Look on ebay for a factory service manual. Would avoid...
  13. topgun3690

    85hp charger speed/prop/rpm concerns

    This is from the lync n sync stickie at the top of the forum..... 10. I can NOT stress this enough! NEVER set the low speed needles less that 3/4 turns out no matter how poor the idle or acceleration. To do so will run the engine too lean and detonation and melted pistons at or near full...
  14. topgun3690

    85hp charger speed/prop/rpm concerns

    This is the one I got off ebay......they are all pretty similar.
  15. topgun3690

    85hp charger speed/prop/rpm concerns

    I think I set mine at 3P = 3 spark per rev. for a 3 cylinder motor.....might try that and see what happens. Am not near my boat right now to verify that setting but pretty sure that one is correct. You have a 2 stroke, but it's not 2 strokes per fire.......it is 3 sparks per rev (for a 3...
  16. topgun3690

    85hp charger speed/prop/rpm concerns

    Are you sure your new tach is compatible with your motor? Is the pole setting on the back set correctly? Maybe get a tiny tach to verify the new tach is showing the right RPMs.....before shelling out money on new props.
  17. topgun3690

    The End

    Most folks here along the Texas Gulf coast didn't think too much about winterizing their boats.....until the Big Freeze of February 2021.....Sadly, a lot of I/O owners paid the price.
  18. topgun3690

    Force 50 ID please

    I would add a spark test to your list......spark should jump a 3/8 inch gap.
  19. topgun3690

    1998 Force 90 ELPT by Mercury Marine

    Aint it amazing, 2 shops said the motor was toast......the third one did some basic carb work, and said it was good to go.......hopefully your next outing on the water confirms it really is fixed. Good luck. (y)
  20. topgun3690

    85 force lower unit drain plug

    That pic shows the filter on the inlet hose to the pump......which won't hurt anything, but you really want it on the pump outlet hose that goes to the carbs.....that way you can tell if the pump is working or not. May have to reroute that outlet hose.....they got it kinda crammed in there...
Top