Search results

  1. K

    Carpet glue

    Thanks for all the help everyone
  2. K

    Carpet glue

    Thanks. Some of the foam on the bottom of the hull was hard and heavy and wet, can you fill some of the hull with the cut foam to reduce the amount of 2 part foam? What is better 1/2 inch or 3/4 inch for the deck, I will be using marine grade plywood even if who ever did this last didn't.
  3. K

    Carpet glue

    Seal for any small leaks going to seal the inside of the hull (not water side) what about gluvit epoxy?
  4. K

    Carpet glue

    Thanks, should I paint the bottom of the hull with flex seal? I am going to use the two part foam.
  5. K

    Carpet glue

    Why do you have to remove the old glue?
  6. K

    Jump seats

    Thanks any good sites on how to fiberglass a boat deck?
  7. K

    Jump seats

    Why epoxy and not a polyester?
  8. K

    Jump seats

    Using exterior plywood marine painted and vinyled Using marine Plywood for the decking will be coating it with fiberglass resin
  9. K

    Jump seats

    I am trying to keep the costs down, and at marine Plywood at over $100 a 4 x 8 sheet it is tough to do. Just the flotation foam will run around $500.
  10. K

    Jump seats

    First going to try rub and restore, if that doesn't work then I will redo the pieces my self. Will sew some design into it over the winter.
  11. K

    Jump seats

    Thanks the dog house is next and the side panels, not in bad shape just sun faded. Looking for away to clean and brighton them.
  12. K

    Jump seats

    A little bit of vinyl cleaner and a whole lot of elbow grease.
  13. K

    Jump seats

    Thanks will look into them
  14. K

    Jump seats

    I rebuild the pedestal for the jump seat, now the seats look even worse. Looking for some cheap white seats that will fit.
  15. K

    Mid 70 18ft ss I/O rebuild

    Try to get the right switch, the only ones I have found were for outboards, went to the boat scrapyard no luck, but one of the old mechanics told me some of the old switches could be taken apart and switched. The switch was held in place by two tabs, pulled it out turned it 180 and snapped it...
  16. K

    Mid 70 18ft ss I/O rebuild

    Electric fuel pump I was thinking of converting to a Electric fuel pump from the mechanical one. Is it difficult, do I need a new tank? Is there a benefit, any safety issue?
  17. K

    Mid 70 18ft ss I/O rebuild

    Thanks guys got the dashboard done
  18. K

    Mid 70 18ft ss I/O rebuild

    Tested the run stop switch, it is closed on off and opened on run. How do you connect it? It was completely disconnected.
  19. K

    Mid 70 18ft ss I/O rebuild

    Thanks guys
  20. K

    Mid 70 18ft ss I/O rebuild

    What do you know about the capacities decal? What information is needed, is it OK to put on the boat.
Top