The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have a used 2002 6 hp 4 stroke me6ml 4st.
The top of the carb is missing some parts.....right where the throttle link 3.5" long wire, hooks to the throttle plate shaft.
All I have is a small coil spring, plastic bushing, small plate with screw but the 3.5" long shaft is hanging and not...
I would like to remove my drive shaft and spray it with silicone to help protect it from rust or pitting but not certain how to remove. If the oem manual is correct it says to remove the engine first but that's hard to believe that just to expose the shaft. Just trying to be proactive since I...
I own a couple of small motors and by far the little 4.5 is the smoothest, quiet and fastest to start of all of them. Also seems to be very easy to maintain. What do you think?
I would like to remove and replace a "shifter" bushing which is located at the bottom of my shifter rod. It appears to be pressed in.
does anyone know how to remove it and do I just press it back in? Looks like there may be a o ring as well.
Replacing this component should help keep the gearcase...
I went in and assembled new drive shaft lip seals and all components that would keep the lower unit oil from leaking into the water pump.
Ran the engine in a lake, ran perfect. Came back and noticed the lower unit oil good but oil/water coming out of the exhaust hole at the bottom. I then...
I removed the shift rod "clip" (next to carb), then removed the trim tab bolt, then the inode bolt and another one right next to the inode then the four main bolts.
I then pushed the shift rod towards the powerhead and disengaged the shift rod (at the top). Seems like this would allow the lower...
