Search results

  1. J

    Maxwell 500

    So I found a different part number for the reverse solenoid from Maxwell to replace p100711 and it is sp5102 which has the ground. The anchor continues to go only down but not up. Once again if I jump the f1 and f2 directly to power the anchor will go up and down. Does the boat need both engines...
  2. J

    Fuel return

    Sorry so I bought this boat and the fuel lines were disconnected and tanks were dry in preparation for storage. The engine is a Volvo penta gxi/e 5.0 3869255. I hooked the smaller of two hoses to the fuel pump and primed it. It ran for a little but stalled out from loosing prime. There is...
  3. J

    Fuel return

    Should Volvo gxi have a fuel return line to the tank and where would it connect to the engine
  4. J

    Help transom leaking

    It’s hard to tell where it is leaking from
  5. J

    Help transom leaking

    I’m going to have someone work on it but he is saying could be bellows
  6. J

    Help transom leaking

    I am ready to run for this thing. We launched the boat today and this is what’s happening.
  7. J

    Trim sensor

    Thank you so much Dubs I am launching on Tuesday so I don’t think a trim sensor is probably worth it. I might just try to tight it. See if it loose. Thank you so much.
  8. J

    Trim sensor

    Great but to be simple I should be able to remove it clean it up and reinstall without removing the drive ?
  9. J

    Trim sensor

    Fantastic any idea of what would remove that
  10. J

    Trim sensor

    Is there a way to fix it
  11. J

    Maxwell 500

    Ok so I put it what Maxwell says is the part replacement for the solenoid it still just clicks but now it clicks in both directions. With the old solenoid it would actually work going down but would not even click when retrieving. The thing that bothers me with this solenoid sp5104 which...
  12. J

    Trim sensor

    So I assume I am missing something this does do thing when the engine goes up or down
  13. J

    Trim sensor

  14. J

    Batteries

    I have 31 ft Larson cabrio with twin 5.0 gxi. I have two batteries that are wired parallel with a charger. My question is I have an extra battery should I wire it in a parallel with the other two to have three batteries or am I better off with two.
  15. J

    Trim sensor

    Yup so that doesn’t move
  16. J

    Thru hull

    I’m a retired navy guy and coastie I look forward to using 4200 to reminisce lol
  17. J

    Thru hull

    Thank you so much
  18. J

    Trim sensor

    I am sure this is a simple question. I installed new trim sensors on my Volvo DPS outdrives. Starboard is working fine but the port is not. When I turn the sensor by hand it works but once I put it in and attempt to adjust it doesn’t work at all… no movement. The old unit was pretty seized on...
  19. J

    Thru hull

    Hi, I needed to drill a 7/8 hole thru hull to run a new transducer. There was a 1/2 hole already there so I just made it bigger. The old hole was filled with I assume 4200 and the hole is above the water line but not by more than 6 inches. Should I fill the new hole with 4200 or marinetex
  20. J

    High idle

    So the saga continues it is definitely the IAC, but they are backordered from Volvo indefinitely. Is it possible that the engine is to relearn the sensor? What using aftermarket?
Top