Search results

  1. 1985 Century Mustang

    Excessive Oil/Grease by Alternator area.

    I'm getting a sufficient amount of oil by the alternator, I'm not sure where it's coming from, any ideas where I should check? I'm running a 1985 Mercruiser A1-G1 3.0 140hp. The block was rebuilt approx 12 years ago and has about 200 hrs on it since.
  2. 1985 Century Mustang

    Sterndrive Gear Oil - Alpha 1 Gen 1 3.0 140hp

    Hey all, I purchased this gear Oil (pic below) for my Merc A1-G1 Sterndrive. I didn't realize it, but it wasn't the blue colored gear oil like I had in it previously , I put it in anyhow. Is this ok? Is the blue gear oil better?
  3. 1985 Century Mustang

    No water coming out of the exhaust on muffs

    FWIW- Mike's Carburetors on YouTube helped me out tremendously to do my rebuild. Mercruiser Alpha One Gen One Carb.
  4. 1985 Century Mustang

    Engine runs for 1 minute and stalls, then starts with no problem. Merc A1G1 140 HP

    Thanks, It was wired incorrectly. The electric fuel pump wasn't getting any power, I ran the power lead to a ground instead of a positive lead. I just made the correction.
  5. 1985 Century Mustang

    Engine runs for 1 minute and stalls, then starts with no problem. Merc A1G1 140 HP

    I found the issue. When I winterized the boat I took off the positive electric fuel pump wire to run the carb dry while it was running.. When I hooked it up today, The power wire to the electric fuel pump was wired incorrectly. I'm sorry for any useless thread.
  6. 1985 Century Mustang

    Engine runs for 1 minute and stalls, then starts with no problem. Merc A1G1 140 HP

    Does anyone know if the whole inline fuel filter has to be full with gas when running, and or does it have to be primed. That may be the issue too. I only see 1/4" of fuel in the filter while it's running.
  7. 1985 Century Mustang

    Engine runs for 1 minute and stalls, then starts with no problem. Merc A1G1 140 HP

    I just started up the boat today after installing a new water impeller, she runs for a minute and then stalls. Seems like a fuel issue, no doubt. I didn't replace any of the filters yet since last year, Im gonna replace all the filters shortly and see if that is the issue. I still have to do...
  8. 1985 Century Mustang

    No water coming out of the exhaust on muffs

    Hey, can you or anyone here on the forum advise what plastic part this, is and where does it go, it came with the kit. For the life of me I don't know where it goes. (Photo below). One end is a normal circumference, the other end has a lip as shown standing up. I'm thinking maybe it fits over...
  9. 1985 Century Mustang

    No water coming out of the exhaust on muffs

    I didn't know this, my engine is a rebuilt 1985 Mercruiser 140 HP it's not a newer engine. Does it make a difference?
  10. 1985 Century Mustang

    No water coming out of the exhaust on muffs

    Everything looked good, no melting etc. I don't use a T Stat, so I guess that's one less thing to worry about with respect to clogging up there.
  11. 1985 Century Mustang

    Some Play In Lower End Propeller Shaft Mercruiser A1G1 140hp

    I just went side to side with it and noticed play, about a 10th of an inch or less. I'll try that today, as I'm waiting for the impeller kit to come. I just wanted to know if it was normal to have play.
  12. 1985 Century Mustang

    No water coming out of the exhaust on muffs

    Today I had the same problem you had, steam coming out from the center of the prop with the ear muffs on, I shut her down after a few minutes, the temp climbed to 175. I then took the lower end off and found my impeller was wiped out (pic below), and also oddly the water tube was laying in the...
  13. 1985 Century Mustang

    Best buffing compound or cleaner wax

    I actually used comet in a bucket with a green poly pad, came out amazing. Just my 0?2 cents.
  14. 1985 Century Mustang

    Some Play In Lower End Propeller Shaft Mercruiser A1G1 140hp

    How do you know if the bearing around the shaft is good or worn.
  15. 1985 Century Mustang

    Some Play In Lower End Propeller Shaft Mercruiser A1G1 140hp

    Your thoughts, thanks.
  16. 1985 Century Mustang

    Some Play In Lower End Propeller Shaft Mercruiser A1G1 140hp

    I did my water pump today and noticed that the shaft (shown in photo) had some play when I removed the impeller housing and the bottom lower seal assembly under the water impeller housing, is this normal? Could the shaft bearings be shot because of that play?
  17. 1985 Century Mustang

    Winterizing a Merc A1-G1 Block Question Antifreeze

    Yes, and again I think I got a lot of water out of the block, and then I opened up the thermostat and put a gallon of Antifreeze in and closed it up.
  18. 1985 Century Mustang

    Winterizing a Merc A1-G1 Block Question Antifreeze

    Yes I got the plug which was above the oil pan, and a lot of water came out for a minute or so.
  19. 1985 Century Mustang

    Winterizing a Merc A1-G1 Block Question Antifreeze

    There's two plugs on the exhaust manifold. One has a peacock, that seemed like it was sealed permanently shut by either the manufacturer or the owner prior. The other drain plug i took off and a lot of block water poured out. I think I'm in the clear now being I filled up the whole thermostat...
  20. 1985 Century Mustang

    Winterizing a Merc A1-G1 Block Question Antifreeze

    I had drained the block on the exhaust manifold side. A lot of water came out of the block by opening the lower bolt nearest the riser.
Top