Search results

  1. alldodge

    Looking for alignment tools

    Search using goggle
  2. alldodge

    1994 5L EFI Volvo penta

    If key switch doesn't work it can be Ignition fuse blew Key switch went bad Neutral safety switch is bad or throttle handle is not in neutral Connection broke between key switch to neutral switch to Assist relay Yel/Red wire Assist relay is bad Battery cable has a problem/bad connection Battery...
  3. alldodge

    Best "free" fish scanning and verifying/regulation app?

    What about take a pic of the fish and let google tell ya what it is. It will at least get you close
  4. alldodge

    Mercruiser 350 MAG MPI

    Probably came with AC-932 but later Merc changed them to AC 41-993 and these are Iridium and gaped at 0.060 Finding the NGK TR55IX is used in the Ford F150 1997-2010, as well as older GM and a few LS1/LS6 Guess that said, the plug should work fine
  5. alldodge

    Lowe 185 Ski & Fish with Verado 150 – bow won’t lift

    Don't see the weight being your current issue, just wonder why a Verado was installed other than the XS. Just looked up and the Pro XS came into production in August 2007, so may not have been an option at the time More weight might cause the bow to ride higher, so not your issue right now...
  6. alldodge

    1994 5L EFI Volvo penta

    All good, starter has a solenoid The Assist relay sends power on the Yellow/Red wire down to the starter solenoid. So jumping from the Red to Yel/Red on the starter solenoid will cause the motor to crank unless the starter or Battery has a problem. Can even remove the Yel/Red from starter...
  7. alldodge

    Lowe 185 Ski & Fish with Verado 150 – bow won’t lift

    Pro XS 115 weight 163kg (359lb) Verado 150 weight 231kg (509lb) Pro XS 150 weight 207kg (456lb) The vids on line do not have anyone on the bow, your vid does have someone there The Lowe boat uses the Pro XS so your a bit heavier. Wonder how/why someone put a Verado on the boat instead of XS...
  8. alldodge

    Electronic steering

    My boat (OB) has electric/hydraulic steering. Has a electric motor turning a hydraulic pump, if E-motor stops it gets extremely hard to steer
  9. alldodge

    1994 5L EFI Volvo penta

    I don't know which starter you have, but if it has more than one main Battery cable connection, than you should be able to jump from the small terminal closest to the block to Battery cable and the starter should engage If you only have one Battery cable connection than the assist relay...
  10. alldodge

    1994 5L EFI Volvo penta

    If your jumping the assist (slave) relay and nothing happens than it's probably the relay If your jumping the starter solenoid mounted on the starter than most likely the starter or the battery. Wiring is for 5.0 and 5.8. Assist wire going from Assist to starter is not shown
  11. alldodge

    Finally. Some warm times.

    Yesterday morning not bad Buddy came over and had the shop overhead door open and having a couple beers around 1PM (60*). By 2:30 temps dropped about 20 degrees, so we closed up shop. This morning was 26*
  12. alldodge

    Looking for alignment tools

    Search Mercruiser alignment tool, many sell them. They work on Merc, VP and OMC Dimensions of tool
  13. alldodge

    Mercruiser 350 MAG MPI

    With it being a reman motor the serial number won't be there. What year is the boat? Jason does bring up a good point about checking compression. Diacom will be able to read codes and that could be the issue. It also has a record feature, start recording from when motor is started until it's...
  14. alldodge

    2003 150 Sport - Old DECALS / STICKERS?

    Welcome Don't know for sure but with the boat not being that old, you should be able to contact Whaler Whaler
  15. alldodge

    Mercruiser 350 MAG MPI

    What is the serial number? The cam sensor can be replaced but right now I don't see it as causing excessive fuel. This that can cause excessive fuel are the MAP, Temp (MAP/T) sensor(s). TPS or a vacuum leak You need a scanner, and while Dicom would be best the TechMate would help. Need to see...
  16. alldodge

    Mercruiser 350 MAG MPI

    Injectors tested and good Later found 1 injector stuck open Replaced that injector and still running rich FT mentioned I could just be a sensor telling the ECM it needs more fuel. As before you need a scanner to see what the sensors are telling the ECM. Your fuel pressure looks good and...
  17. alldodge

    Boats from work.

    nice work
  18. alldodge

    Twin Merc 250 fuel burn difference's

    Great to see you back again The reason for the post is this is pretty close to what I was seeing with the starboard motor. The starboard was showing a slight bit more fuel burn and when the Tech was fixing another issue he found the FMS had a problem. I'm not turning the helm much and note it...
  19. alldodge

    I/O (Sterndrive) Conversion to Outboards

    So decided to go with the weight equivalent of the V10 instead of V8
  20. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Looks good, did ya ever think about aluminum plate or honeycomb aluminum plate?
Top