Search results

  1. F

    Water Dripping From Transom Screw Hole

    In the process of replacing it, I removed the pitot bracket from the transom of my '84 Sea Ray cuddy this evening. Water immediately began dripping from the lowest screw hole. I watched it and timed it- a drip every two seconds for at least 20 minutes. I stopped watching after that. The boat...
  2. F

    DP-S Shifting

    I recently noticed that when shifting from neutral to forward with my DP-S drive, it is taking a moment to to make the change. There doesn't seem to be a commensurate delay when shifting from neutral to reverse. Is there an issue that needs to be addressed?
  3. F

    Engine Swap- agallant80

    Whatever happened with the blown engine on the Excursion tow vehicle?
  4. F

    Cleaning Outdrive

    I'm going to pull my Merc MR-1 equipped boat out of the water next week. It has been in the water since mid-April and the outdrive will be a gunky mess! I need "best practice" ideas on how to clean it.
  5. F

    Setting Jack Stands to Support Tandem Axle Trailer

    I'm going to remove all four wheels from my tandem axle trailer while it has a 5,000 pound boat on it. I plan to set the two pairs of jack stands at four points around the trailer frame and not on the axles. Is this the best way to do this? Better dumb questions than dumb mistakes.
  6. F

    Fluctuating Oil Pressure- Bad Sender

    The oil pressure indication on my Merc 228R I/O was fluctuating 5-10psi. This engine is 30 years-old with 775 hours. I feared the worst, but carefully troubleshot the issue and discovered the cause was the oil pressure sender. It was easy to replace and now my oil pressure is steady. I...
  7. F

    Too Much Boat?

    Looks like a mismatch to me. A commenter reported he met the rig on a narrow road and the driver was going too fast for conditions. There is a major boat yard in the area. Boat, truck crash on KY 93 removed
  8. F

    Chunk of Cavitation Plate Broke Off

    I put my 1984 Sea Ray cuddy in the water for the first time this season. Enroute to the marina via the Ohio River (about 10 miles), a chunk of the cavitation plate of the MR-1 outdrive cracked and broke off. The section is about 10 inches long and the missing part starts at the "fin" anode at...
  9. F

    MR-1 Gear Oil Quantity Check

    As part of winter layup last fall, I changed the oil in my MR-1 outdrive. I'm getting the boat ready to go for this weekend and I checked the gear oil level by removing the vent screw at the top of the drive. When I turned the screw about one full turn, there was a brief noise that sounded...
  10. F

    Thunder Over Louisville 2014

    Anybody planning to be on the Ohio River for Thunder 2014? I'm planning to be there in my 21' Sea Ray cuddy at least for the Blue Angels. Whether I stay for the fireworks depends on the debris level and number of boats. I really don't like the mad rush of boats afterwards, plus I've got a...
  11. F

    Bottom Painting Issue

    I had the bottom of my 1984 Sea Ray cuddy repainted by a local shop with a good reputation. I went to check on it today and the boat was done and back on the trailer. To my surprise, I noticed rectangular unpainted patches where the boat bottom rested on hull supports while being painted. To...
  12. F

    Liquid Rollers Bunk Lubricant

    I have used silicone spray to lubricate the bunks on my boat trailers. While browsing the shelves in the boating section of a variety store near Kentucky Lake, I ran across "Liquid Rollers" by Marykate, a CRC brand. My Four Winns trailer was due for bunk lubricant so I decided to give it a...
  13. F

    Change in Shift Behavior After Drive Pull

    Drive: DP-S Duoprop Engine: 5.0 GXiB I had the drive pulled in the spring for routine service. Due to weather, schedule, etc., this weekend was the first opportunity I've had to use the boat. The shifting behavior is different than I remember it being from last season. Specifically, when...
  14. F

    Any iBoaters Near Nottingham in the UK?

    I have a 60-hour layover in Nottingham arriving early morning August 17 and departing early evening August 19. Any iBoaters near there interested in boating activities with a Yank? I can hire a car or hop a train. It may involve one other person depending on whether a colleague wants to join me.
  15. F

    Replacing '80s Sea Ray Portlights

    I got zero response in the Restoration section, so I'll give it a shot here. For better ventilation in the cuddy, I'd like to replace the portlights on my 1984 Sea Ray cuddy with screened models that open. Is this feasible? If so, what manufacturer and model? For reference of size and...
  16. F

    Replacing "Cat Eye" Sea Ray Portlights

    For better ventilation in the cuddy, I'd like to replace the portlights on my 1984 Sea Ray cuddy with screened models that open. Is this feasible? If so, what manufacturer and model? For reference of size and design, the portlight style is the one seen on most 1980s vintage Sea Ray cabin boats.
  17. F

    Bilge Drain Plug Assembly Replacement

    I'm replacing the garboard assembly that drains the bilge on my 1984 Sea Ray cuddy. The picture shows the surface area around the hole in the transom where the garboard assembly is inserted. The old assembly didn't leak, but the depression missing gelcoat at the 3-4 o'clock position bothers...
  18. F

    Alpha 1 Trim Cylinder Anchor Pin Lube

    I removed the anchor pin from the aft end of the power trim cylinders so that I could move them while painting the drive. The pin was somewhat difficult to remove and I'd like to lube it before reinstalling it. Is this acceptable? The Mercrusier manual doesn't address it. if it's OK, what...
  19. F

    Boat Launch Ramp N. KY/Cincinnati

    I am planning to trailer my 21' Sea Ray cuddy from Louisville to northern Kentucky and launch for a cruise up to Augusta for an overnight at a B&B there. What are my launch options with overnight truck and trailer parking in the NKY or Cincinnati area?
  20. F

    V-P Duoprop Spare

    I have a Volvo-Penta Duoprop drive with stainless props. What are the options for carrying a spare prop system? Thankfully I've not needed one on the water, but I carry a complete spare prop (and associated parts) for the Alpha 1 on my Sea Ray cuddy and would like to do the same for the V-P.
Top