Most likely the carb needs work.
Verify fuel is squirting. Make sure the choke works
Being a 1990 cruisers make sure you do not have moisture in the transom and stringers
Most cruisers boats of that era would have needed repair long before 2025.
Ted, this is outside my realm of knowledge. I believe that DTS is CAN based and needs the network dragged over to run them. (speculating). I did recommend having a video of them running on the hard prior to pulling them.
I can reach out to a former employee in the controls group at...
Did you look at the links I posted ? All the answers are in the thread in link 14
from post #30
here https://forums.iboats.com/threads/how-tos-and-other-great-information.283508/
Read links 14, 15, 17, 18, 2, 3, 4a, and 4b in their entirety
you wont find a new block as GM moved from that platform in 2014.
even the old SBC you wont find new GM blocks, only aftermarket
your best bet is find a 2007-2014 GM truck and pull the motor. this is also about 1/3 the cost of rebuilding a motor. you can get a low mileage 4.3 from a late...
first, welcome aboard.
the "234" block is the 2007-2014 motor. base model Silverado and Siera trucks had them as well.
why do you say you need a new block? did you freeze bust it? if so, you also need new heads, intake manifold and exhaust manifolds
cheapest to get whole long-block at that...
agreed, look here. https://forums.iboats.com/threads/how-tos-and-other-great-information.283508/
look at link 14, go thru that in its entirety. look at every photograph, watch every video.
then go on to links 15, 17, 18, 2, 3, 4a, and 4b
Nida is not far behind it.
however in the case of a 90's boat, its an option. I personally would use ACX or BCX at $35 a sheet as it will last another 20-30 years and by then the boat will have been sold/replaced/etc.
Balsa is a great core material and still used today on many larger boats. the cockpit sole and the foredeck on my boat are all balsa core and even Ted's Cruiser has a balsa core foredeck
dont focus too much on the current stringer and how it was fabricated. a single piece of 3/4" with a strip...
volvo pump paint came from the pump heat exchanger vendor that went to the tier 2 fuel system supplier for assembly. (same tier 2 supplier base that is used by other boat engine OEMs). its actually powdercoat and wasnt an issue for many years until E10 was used.
how is any of that relevant to...
the vinyl looks like it has torn on the edge. on most door cards, usually it wraps about an inch around the back side. the only two choices is a red-neck-engineer fix like you mention with silly-cone or other, or pull the door card and do it right by pulling the center out of the panel and...
