Wellcraft 210 Elite Restoration NEED HELP!!

[Elite210Captain]

@MikeSchinlaub no the first layer is 3" 1.5ozCSM inches then 5"WR then 7"CSM, then 9"WR , then 11"CSM total of 5 layers. Done with the first layer time for the next, i might have to wait until tomorrow i only have about 1/4- 1/2 gallon of resin left im not even sure if that would be enough for the woven roven.

 

[Elite210Captain]

@MikeSchinlaub finished the 2nd layer and ran out of resin that WR is thick.

 

[Elite210Captain]

Finished up layers 3, 4 and 5 this morning glad to be done with the glassing in part of the transom just some minor hole cleaning out to be done. was thinking about putting 1 layer of csm around the transom cutout as i didnt wrap the glass around that curve of the cutout but theres plenty of resin encasulating that wood, there have been a few people mentioning the smell of the resin.

 

[Drivewayboater2]

Looking good. Be mindful of the keyhole thickness if you are adding an extra layer. Check your min/max thickness specs of transom. I almost made the mistake of overdoing mine. Good luck.

 

[redneck joe]

some say not worth it but also may want to glass the edges of the keyhole.