FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hey there again mates,
I have a 1981 Glastron SSV-151 16 foot openbow with a 1981 70 hp Johnson model J70ELCIH. I have the carbs off to rebuild them and was kicking aroung the idea of installing a set of Boyesen reeds since I have the carbs off. Would any re-jetting be necessary afterwards...
Hello again,
I have a chance to pick up a 1980's Glastron 16 footer with a 1985 90 HP Johnson Model # J90MLCOS for what seems to be a good deal. The owner stated over the phone that the engine came off a poontoon boat that had two engines. I asked him which way the prop would spin if moving the...
Hello again Mates,
I have a question about OMC tilt/trum unit #173827 Vs. #773530. I have a 1981 16 ft. Glastron SSV-151 with a 70 hp Johnson and want to add power tilt/trim to it. I was looking at OMC add on power tilt/trim kit #773530 that looked like it would fit my application then ran...
Hello,
I was wondering if there is a steering to tiller conversion for 3 cylinder Evinrude/Johnson's? If so are they still available? I'm looking at motors from late 70's to present. Thanks.
Hello,
I'm new to this site and wanted to tell you that I find it's packed full of good info in just the short amount of time I've been here.
I also wanted to ask about an OMC test wheel I'm looking for for my 1981 Johnson 70hp model #J70ELCIH. It seems that I'm getting confused about the cast...
