Pulled my 1989 Sea Ray 30Ft Weekender into my well And plugged the power cord in. Apprx, 4 days, I went back to the boat and tried to start it, and the whole starboard side is totally dead. I tried to trouble shoot a little (battery cables, Made sure the toggle switch above the key was on, )...
I have a 2006 Searay 270 Amberjack. One of the spigots on the bathroom sink is leaking. After calling several searay dealers, I was advised that the faucet is discontinued, and I would probably have to buy the whole assembly ($260.00) One of the dealers did tell me that there is someplace on...
Does anyone know of someone or somewhere that I might find information on replacing the raw water impeller on enclosed cooling system on a 396cu.in. 375hp B-III? Thanks Ray
Does anyone out there have any info or video on how to change a water pump on a 496cu.in bravo III with an enclosed cooling system? I sure could use any instructions. with the enclosed cooling system, you cant even see the pump.
Thanks Ray edit;
A while back, someone showed me how to download the manual for a 2006 mercruiser 496 cu in 375 hp engine.
I need to change the inclosed cooling systen fluid this year, and when I went into my documents, it was gone.
Can someone show me how to get into the manuals or maybe walk me through the...
This motor has the water separator filter next to the water pump. And it also has an enclosed cooling system.
Can anyone walk me through the steps for replacing. the impeller? (bravoIII with enclosed cooling system)
Thanks Ray
Every once in a while, when I attempt to accelerate from an idle, the motor will bog and stall out. If can choke it
before it stalls, It will than accelerate. Any suggestions?
There are two drain holes located in the cockpit, at the rear of my boat. If I step to the rear of the boat, lake water enters through these holes. Then if I move to the front of the boat, the water will not drain out. Eventually, the water will seep out into the bilge through the battery...
I just bought a 2001 fishing boat with a 2001 115 HP yamaha 2-stroke.
The manual wasn't with the boat.
Can anyone tell me where I might be able to download a service manual for this motor.
Also, where would I find the Serial number on this motor?
Thanks Ray Gibraltar Mi.
Could anyone out there assist me in winterizing an enclosed cooling system 496 ci.in. 375hp?
I dont know what the blue hand pump is used for thats clipped on the motor. For all intents and purposes, could I connect a hose to the outdrive and run anit-freeze through it, and not worrying...
While Replacing a blown head gasket, I noticed a pitting between #2 & 3 Cyl.
Its not very deep. I could lay a piece of dental floss in it.
The head is in good shape. I cant throw any more money into this money pit. Has anyone used this high temp repair compound from permatex? Or maybe another...
I had 20PSI in #2 Cyl. Thinking thaqt it was a burnt valve, I removed the head, found that the head gasket was blown between #2&3 Cylinders.
I also discovered that there is a hair line crack between these cylinders. Its not much deeper than a piece of dental floss.
Its an old boat and I cant...
IMPELLER REPLACE HELP.
I have a 15HP 1986 evanrude motor thats been in storage for about 12 Yrs. I'll be pulling it out of mothballs this summer and i'd like to replace the impeller. Would one of you fella's be so kind as to walk me thru the steps? I'm not sure about the shift rail, hidden...