FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Re: Fiberglass/Hull Repair Advice - Pics Posted
Ok, did an acetone cleaning of the area. Took more pictures. Hopefully they're more informative for you all.
The bigger gouge under is the hull is completely dry, so I'm not as worries about that one.
However, the transom area gouge is...
Re: Fiberglass/Hull Repair Advice - Pics Posted
Hello and thank you for helping.
I will take some better pictures when I get a chance. The first two pics (of the same gouge) is port quarter as seen in this picture. The third gouge is smack middle on the bottom of the hull. The first gouge...
Hey All,
Just pulled my boat for a cleaning, found the following fiberglass cracks. I have no fiberglass repair experience but want to do the job myself to save money. Thoughts on the severity? Any product suggestions?
Thanks in advance
Hey All,
'88 OMC 2.3L Cobra.
Long story short:
A week ago I realized I had a cracked bellows after pulling her from the water. Drained outdrive immediately, about a quarter cup of water came out followed by milky frothy oil. Pulled off outdrive, cleaned/regreased u-joints, gimble bearings...
Hey All,
I have a 88' Ford 2.3 OMC Cobra. At high speeds, she'll randomly dip down a bit in power, then about 10 seconds later usually go back up (without me touching the throttle the whole time). Any thoughts?
Thanks in advance.
