Search results

  1. S

    Fiberglass/Hull Repair Advice - Pics Posted

    Re: Fiberglass/Hull Repair Advice - Pics Posted
  2. S

    Fiberglass/Hull Repair Advice - Pics Posted

    Re: Fiberglass/Hull Repair Advice - Pics Posted
  3. S

    Fiberglass/Hull Repair Advice - Pics Posted

    Re: Fiberglass/Hull Repair Advice - Pics Posted
  4. S

    Fiberglass/Hull Repair Advice - Pics Posted

    Re: Fiberglass/Hull Repair Advice - Pics Posted Ok, did an acetone cleaning of the area. Took more pictures. Hopefully they're more informative for you all. The bigger gouge under is the hull is completely dry, so I'm not as worries about that one. However, the transom area gouge is...
  5. S

    Fiberglass/Hull Repair Advice - Pics Posted

    Re: Fiberglass/Hull Repair Advice - Pics Posted Hello and thank you for helping. I will take some better pictures when I get a chance. The first two pics (of the same gouge) is port quarter as seen in this picture. The third gouge is smack middle on the bottom of the hull. The first gouge...
  6. S

    Fiberglass/Hull Repair Advice - Pics Posted

    Hey All, Just pulled my boat for a cleaning, found the following fiberglass cracks. I have no fiberglass repair experience but want to do the job myself to save money. Thoughts on the severity? Any product suggestions? Thanks in advance
  7. S

    Water in Outdrive? OMC 2.3L '88 Cobra

    Hey All, '88 OMC 2.3L Cobra. Long story short: A week ago I realized I had a cracked bellows after pulling her from the water. Drained outdrive immediately, about a quarter cup of water came out followed by milky frothy oil. Pulled off outdrive, cleaned/regreased u-joints, gimble bearings...
  8. S

    1988' Ford 2.3 OMC 4-cylinder Cobra Engine Issue

    Hey All, I have a 88' Ford 2.3 OMC Cobra. At high speeds, she'll randomly dip down a bit in power, then about 10 seconds later usually go back up (without me touching the throttle the whole time). Any thoughts? Thanks in advance.
Top