Recent content by SoTxFisher

  1. SoTxFisher

    Mercury Mariner Tilt/Assist rigged up on a 1989 Evinrude 48 SPL...

    Mercury Mariner Tilt/Assist rigged up on a 1989 Evinrude 48 SPL... (tilt assist unit bought for $250 on ebay working) The top piston rod clevis had to be thinned a bit on either side about 1/8 inch to fit nicely.. used a cutoff wheel.. upper pin is exact fit.. lower pin is exact fit. The...
  2. SoTxFisher

    1989 Evinrude 48 SPL paint project...

    Just a project I was working on.... 1989 Evinrude 48 SPL.. had some bad paint issues... stripped most of the bad areas down, then sanded and sanded and sanded using different grits till smooth.. then a Krylon dark grey primer.. several coats, wet sanding in between... then the final several...
  3. SoTxFisher

    1982 Ski Barge restoration, then modification photos.. work thru and completion.

    Just some photos of the boat when I first bought it.. looked like a swimming pool with the blue interior.. then my conversion to a bay boat with decks (brown carpet), and then completely gutted it out again and built carpeted decks on top and turned it into a scooter type bay boat.. originally...
  4. SoTxFisher

    For those w/Evinrude 48 SPL (1989 model here) Cam, idle adjustment, linkages..

    Can't find the write-up on how to do the "linkage sync" procedure on here... anyone got a direct pointer to it? Also, anyone else with this motor notice the linkages a bit loose.. they shimmy and bit from side to side and even forwards and backwards along the route they normally travel when you...
  5. SoTxFisher

    89 Evinrude 48 SPL Carb #432986/Setting float level/Where is the adjustment for this?

    Did a carb clean, had some idling issue where #2 cylinder was not firing.. got carbs cleaned good, engine is idling decent now, but in the instructios for carb cleaning and adjustment.. it states to hold the carb upside down/right side up to and blow compressed air thru to test that its working...
Top