FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Been having some issues with my boat lately and not really sure where to go from here. It’s a 1999 20’ chris craft with a 5.0gi tbi. At the beginning of the summer the ecm stopped giving signal to the fuel pump relay. I ended up bypassing the relay and throwing 12v from the ignition to the fuel...
It is a GI-A since I have never done it, I ended up doing cap,rotor,plugs and wires with no change. I also checked the fuel pressure and am getting 30psi with no change. I had a friend watch it as I cruised around the pressure remained the same at all speeds and he also watched the injectors and...
boat is currently having issues at take off. It does ok if I slowly take off but if I pin the throttle it will bog right down and not accelerate very well. I’m thinking a tune up but not sure. What do you guys think?
I’m currently have an issue with the fuel pump relay not getting power to the fuel pumps(high and low pressure). I have checked the relays but am not getting the proper ground from the wire that goes from the ecm to the relay. As a quick fix I have resulted in taking power from the ignition...
Also where can I a printable version of the wiring diagram you provided? And worst case scenario where can I get the eco repaired and what does it cost?
Thanks
Really not what I was hoping to hear.. was also thinking one of the fuses in line. How do I get to the fuses? Are they just wrapped in tape with the wires? I couldn’t seem to find a fuse box of any sort.
Having an issue with my 1999 Volvo penta 5.0 gi getting power to the fuel pump.
So far I have replaced the fuel pump and both relays next to the fuel pump still not getting fuel.
I have checked the kill switch aswell.
I was able to bypass the relay and put direct power to the fuel pump...
