FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Ran through some debris due to other boats blocking me from being able to avoid it. Some piece of wood (most likely) caught the prop and was pushed up into the left side of my cavitation plate, breaking off a very large piece. The main drive housing is fine and the chunk broke clean. It's an...
I'm in a new house with a new driveway as of last year. At the beginning of last summer, I was driving the boat out of the garage and the front of the outdrive "bullet" scraped the driveway. It seemed minor at the time and I could barely feel it with my finger. It seemed like it only took...
I have searched all over for an answer to this question. I am replacing the tach on my boat (1995) and the tach, which is a teleflex amgega 0-6k tach, has what looks like heat shrink covered push on connections. The wires are covered in heat shrink and look like they are just pushed onto the...
Hello all, I have been a reader for years and now I have a question. I had to cut out my front engine mount to replace the wood. It's a 3.0lx. I have prepared the area to fiberglass over the new wood but my question is will epoxy resin stick to the grey paint used in the bilge. I have...
