Recent content by Open Water

  1. O

    Larson? 58 or later.

    I’m the owner of this boat. It’s a Pipestone, I’ve got a feeling it’s an Arrow, or a Chieftain. Guessing the motor is not original. Any information would be appreciated. Built in Pipestone Minn
  2. O

    Larson? 58 or later.

  3. O

    Larson? 58 or later.

    Having trouble with my photos
  4. O

    Larson? 58 or later.

    Any idea what this is. Was the raised bow thing added?
  5. O

    1988 Johnson 70hp - VRO or not to VRO?

    2.6 oz of oil per gallon of gas. Peace of mind.
  6. O

    Evinrude big twin 40

    The muffler belt is fine
  7. O

    Evinrude big twin 40

  8. O

    Evinrude big twin 40

    The leading cause of vibration is propeller damage. Now that I had it refurbished it’s better. I’m not going to change the prop. Engine isn’t lugging or over revving. No tach on this thing
  9. O

    Evinrude big twin 40

    Well, replaced driveshaft, plate under water impeller, top driveshaft seal/ again, and added heat shield to control wire. Yesterday was 85 in MN. Took her out for a good test run. Gear lube looks good, not perfect but better. I’m going to stop with this lower unit before I break it. I’ll switch...
  10. O

    1978 Johnson 140hp running rough. Need advice

    Berryman carb cleaner. Gallon can, remove carb soak according to label. Replace/rebuild kit. Might just help you out.
  11. O

    Evinrude big twin 40

    This sat for 4 days, it’s better. I’ve got the parts ordered.
  12. O

    Evinrude big twin 40

    New driveshaft is 200.00 I was leaning in that direction. I see now there is supposed to be a heat shield over the control wires leading to the lower unit. We’ll see if that is available. I’ve got time, won’t see hard water here till about Thanksgiving.
  13. O

    Evinrude big twin 40

    H Had Pressure test done before I changed seals and o’rings. Guy said it held all night. Go figure, but I was getting water in. The bubble test sounds good, at least it’s something I can see. What do I use? Tube, gauge, stater valve ? How much air pressure?
  14. O

    Evinrude big twin 40

    Well I spoke too soon. The lower unit still has water getting into the oil. Went for a ride on Lake Minnetonka yesterday. Found out this 14’ is no match for the wakes made by the rigs on that lake. The only part I haven’t changed is the driveshaft. Gave it a good run, from Gray’s bay landing to...
  15. O

    VRO Pump Question

    Have you considered mixing 50:1 in the tank. Did that with a 1990 Johnson 140 VRO and it idled perfectly. Wish I had done it much sooner.
See more
Top