If your not quiet getting your lower unit into reverse after going through the adjustment procedure, By moving the stud up in the slot It gives you more adjustment for reverse gear only
I suppose this is an indication of a worn control shift cable, (the lowers have been replaced) to adjust the shift cable I had to deviate from the manuals procedure and do a little (or alot) of tweeking. How many have done this untill the cables can be replaced?
I needed to change the shift shaft housing and seals for the ccw alpha one gen 2 in doing so I was not aware there were not any alignment marks nor did I make any so what is the correct way to put the shaft back in? Thanks for your input.
Ok im totally confused, if someone could straighten me out I would greatly appreciate it. I have a gen 2 ccw rotation out drive I have looked at all the videos available but I can't find one that really helps me. Here's the issue first when removing and installing you should be in wot forward...
I bought the above mentioned garmin because it has the nmea 2000 feature but I have yet to network it I found out today that it does have video inputs is there away around still using the garmin as a video screen? Question 2 what is networked with yours?
I'm working on a alpha one mr and I want to make sure the gear lash is set correctly. I know this much, the shaft has a needle bearing at the bottom and a taper roller bearing at the top with the taper being wider at the bottom of the bearing you would shim somewhere,after that I would only be...
Not sure if your affected by this in your area but the Quad Cities Mississippi river area seems to have a problem of the barges taking over a good portion of the beaches.They park these barges parrell to any stretch of land that they feel they want to, it doesn't matter if its obvious if its a...