I am resealing the lower unit and the two seal's right below the water pump I am in need of advice on. My kit came with two seals of the same outer size but one has a thicker rubber than the other. I didn't see a differance on disasembly but I realy didn;t look. should the heavier seal be...
OK switched over to boyesen reeds and the instructions tell me to drop 5 Thousands (sizes0 on air jets (have 36) so need 31. Where can one purchase these???
About to torch off my 110 evinrude 89 and when I had a link and sync done years ago on a 150 yamaha I had the Mech. just disconnected the advance arm and manualy moved the advance to full advance with the motor running at idle. He was checking max advance with a timing light with the motor just...
Will be building my 89 110 motor shortly and have purchased the factory Manual the talk's of a OMC Alignment Fixture to hold the rod cap for assembly. I do not have this fixture. What is the correct way to align the caps without it???? Also any do's and do-not use for grease for assembly of the...
What fuel pump can I use on my 89 110 evinrude to replace the broken vro pump??? The sticky link for this replacement pump says (page not found) in the top secret files. Also after install of my rebuilt power head do I realy want to run 24-1 for the breakin, and then 50-1 after breakin???? THANK YOU
Have two jugs scored and am going to bore to 030 I hope. What is the piston to cylinder clearance. I have a clymer book and it just says go 030 over stock. Allso are siera parts any good or should a guy stay with evinrude. Looking like about 1500 bucks for pistons and gaskets and bearings and...
