Mc Tool's latest activity

The m is the dia in mm , but I have always called them double torx drive ( I know that aint the official term ) . Torx drives have 6...

I think somebody here would get another 12 years out of that ....just keep an eye on your water pressure gauge :LOL::LOL:

Huh , reminds me of an MRI scanner :D

https://www.facebook.com/share/r/19sgUeMadw/

Good skills Flathead , bet that took a while . I do a few repairs but not at your skill level ....like mine look like repairs . Gotta...

I think that they are designed to be difficult to disconnect .... least they come off accidently . My Tohatsu has a push fit thing...

Yeah , its not like they stretch a 50hp up to 70hp , they build a 70 hp and then detune it down to 50hp . Some things are hard to change...

Just because the Displacement is the same, doesn't mean a change in Jets or Timing will turn a 50hp into a 70hp. Porting, Pistons...

You may have either a broken ot some weak valve springs. To replace them you will have to remove the manifolds. They are easy to...

It’s imperative that you pay close attention to the plywood edges. This is the problem with plywood. This is where water intrusion will...

The way the wires are crumbling as I remove them, including the wires coming from the stator, I plan on rebuilding the whole harness -...

When you do get it out make sure you wire brush the bejesus out of the inside of the tilt tube , flush it out and pack the grease into...

yeah there is something about holding the book in your hand .... its the oily finger prints all over the pages of the section pertaining...

Thanks, I bought a physical service/shop manual.

There is a product that screws onto the open end of the steering rod, and seals it with an oring. Search "Steering tube cable grease...