Mc Tool's latest activity

I made up a pusher . steel tube with nut ( same size as end of tilt tube thread ) welded on one end , 14mm nut welded on tother , and...

Usually if you can rock the shift rod front to back with a pipe or monkey wrench, with penetrating oil and some rags for cleaning the...

A clean piston like that is usually caused by water intrusion. Look at the head gasket and see if you can tell if it was leaking. And...

Mmmm bugger ! Looks like there are 3 either bulges or discolorations down the left side adjacent to the three nuts on the right side...

I have a 5kg cylinder of Co2 with a bit of hose on it , never used it on a fire but it doubles as a spare welding cyl and we used it...

The inner most flue is one piece from the top of the burner to the cap , 6" seamless stainless steel , I know I previously said 5" but I...

can you get into the switch box ? is there a circuit board you can see ? . Im just thinking that by the way you describe your...

My flue is straight , supported just above the ceiling and just below the roof on the inside . Flue is single 5" to the ceiling and...

yeah , part of my colon and a bit of jejunum , had a bag for a year ....motorbike crash . opp site keeps herniating .

My friend has this set up and he uses cheaper corrugated iron sheet ( we call it Zincalume , nice and shiny but pita coz you cant...

Recon you could go straight up an out the roof with no bends and still put the heater in the corner,?

Yay .....sounds like you got lucky . I have seen some 2 strokes grind to a halt thru lack of lube or overheating , or not enough bore...

Re your comment about digital meters averaging things out .... I was thinking about the fact that they provide an RMS reading , and was...

I dunno so much about log burners , but when I was running the show I had two gas fitters installing gas fires and one thing I learnt is...

Check points gap too , to much dwell time can cause a coil to run hot .