FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hello I need some help please. So the most important question I have is can I hook up vessel view mobile WITHOUT using a terminator resistor cap on the harness? By using it I mean just turning the key on and checking the stats and not running it.
Anyways so I just picked up this boat with an...
So now I put both the old and new needle in and sprayed some pb blaster on the needle and blew some compressed air into the intake of the carb and I could hear and see the bubbles coming out from around the needle. The needles aren’t seating correctly.
I just did the same thing to the top carb and I can very slightly hear a tiny bit of air coming out. Not much at all tho. When I pushed the needle down damn near all of the noise stopped. Not sure if a little bit is acceptable or none is
So I just blew some compressed air into the intake hose and moved the float up and down to see if the needle was seating and it was when I pushed the needle down I stopped hearing the air so
Hey so when I pump the primer bulb gas is leaking out of only one carb. I took the carb off and took the float bowl out and cleaned it. Didn’t look that dirty. Everything looked normal but I’ve also only cleaned carbs a handful of times. So we will have to see what happens when I put it back on...
