Recent content by KC9000

  1. K

    1975 25 hp evinrude 25502B

    Yes. Forsure. My client will be happy. You guys are the best!!! Thanks again. I am always grateful for this site and all the great advice!! Thank you everyone.
  2. K

    1975 25 hp evinrude 25502B

    Ok so found the issue. Thank you guys for the advice you all are in the right spot. Tested bottom coil spark it jumped 5/16 and shocked me. I decided to throw some electrical tape on my new cheap ass coils plug boot. It stopped leaking spark and she is idling like a dream. I cleaned the carb as...
  3. K

    1975 25 hp evinrude 25502B

    Tiller and pull rope Will test and post the 5/16 gap 1/8 turn on rich / lean adjustment No fiber washer between coil and powerhead. Coil ground wire Between coil and powerhead. No washer separating those. As a test. I am going to put some new wire from magneto to coil to see it those wires are...
  4. K

    1975 25 hp evinrude 25502B

    Top - 6.88k Bottom - 6.68k I forgot to mention I installed new champion J4C spark plugs gapped at .030 with feeler gauge. Pulled those and they are getting fuel and looks very even. I also tested with stop button removed with same issues. I feel like the old ignition wires from magneto have...
  5. K

    1975 25 hp evinrude 25502B

    I have this project. 1975 25 hp evinrude. 120 compression both cylinders. I have to have it 1/4 inch past armature marks to start it. I have tried the needle setting at 1 1/2 all the way to 3 turns out. Turning and waiting 1/8 inch at a time. Will not start with carb flap closed in lowest...
  6. K

    Hangkai 6hp T6

    I got a new one on order. They don't sell rebuild kits for this. I'll look up the yamaha version see if it's similar.
  7. K

    Hangkai 6hp T6

    I Originally posted this to wrong thread. I had a client put really bad gas in the onboard tank and ran it for 15 minutes and he said it just stopped. The gas had floating stuff. He said it was one of the pre mix cans of 50:1 off the store shelf. This T6 Hangkai will start on full throttle only...
  8. K

    Hangkai 6hp T6

    Had a client put really bad gas in the onboard tank and ran it for 15 minutes and he said it just stopped. The gas had floating stuff. He said it was one of the pre mix cans of 50:1. These Hangkai motors are similar to the tohatsu motors. I have this T6 Hangkai that will start on full throttle...
  9. K

    1988 25hp Evinrude - No Start

    Yes racerone nailed it. I did check flywheel key and it was in perfect shape. I did link and sync right out the gate so that was set. This motor first pull started right up. Only had to adjust air fuel needle and she idled nice. Picked this up for 200 bucks. 0 money in it. Got quite the deal...
  10. K

    1988 25hp Evinrude - No Start

    Swapped the wires referenced and it started up!!! Damn you guys are good!!! Just fine tuning from here.
  11. K

    1988 25hp Evinrude - No Start

    Will do. Flywheel key is good. Got the bolt off no issues with my buddies tourqe wrench. Checking that connection today will repost in a bit. Thank you again
  12. K

    1988 25hp Evinrude - No Start

    I was suspect of the flywheel key as well. Got a prob tho. Hit it with my impact wrench and nothing. Nut is not budging. Soaked for 24 hrs in pb blaster and still not moving. Gonna try a friend's impact wrench that's a bit better than mine. Mine is old, still works but may not be powerful...
  13. K

    1988 25hp Evinrude - No Start

    I have picked up a new project. 1988 25HP Evinrude E25RCCA The guy I bought it from said he cleaned carb, fuel pump replaced, and new water pump. This is pull start. I pull it and get nothing. On 3rd or so pull it backfires and seems a bit harder to pull but still no start tho. I saw the link...
  14. K

    2003 Johnson J70PL4STC 70 hp Outboard no start

    That is exactly what happened. Main wiring harness fuse. Had to reference the motor harness diagram. Then found a pic online that showed a similar motor. My buddy checked the fuse and it was blown. Replaced it and he is back in business.
  15. K

    2003 Johnson J70PL4STC 70 hp Outboard no start

See more
Top