FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Re: Bass boat bow control panel.
Hey Silvertip, thanks for getting back. I did forget to mention the run charge switch. I kind of gave up on that one a while back knowing that I would have to run my 6 amp output system from the motor for a long, long time in order to charge even a single lead...
Hello. I have a 1982 glastron Hpv165 bass boat. Can anyone tell me why on the bow electrical control panel there is a 12/24 volt plug, check batt#1&2 switch and a volt meter but no 12/24 volt selector switch? I understand that there are both 12 and 24 volt motor set ups but why have a dual...
Hello. I have a 1982 Johnson 115 with hyd. tilt/trim. I have a problem with inconsistant idle. This motor Idles rough on muffs at around 1000 rpm. Idle is at about 850/900 rpm on water in nuetral. And just in gear at 600 rpm. The problem is when throttled up just a tiny bit to maintain a...
A few months ago I purchased a new to me old 1982 Glastron HPV 165 Bass boat with what I am guessing is a 1982 Johnson 115 outboard with hydraulic tilt/trim. The boat has a few stress cracking areas in the gelcoat but nothing major in my opinion. However, the transom has me wondering if there...
Hello everyone. This is my first post. I was wondering if anyone out there has a hull wiring diagram for a 1982 Glastron Hpv 165. I bought this boat about two months ago and have been doing little things here and there in between fishing trips to try and get this boats original equipment back...
