A week ago took the boat out had it WOT for about 15 seconds and the warning buzzer came on steady. Checked water temp and oil pressure gauges, normal. Killed throttle immediately shut it down. popped the hatch and checked everything I thought it could be-drive lube, oil level etc. didn't find...
You guys have been very instrumental in my efforts to get this thing going. It's now 95% complete and running with no issues. The other 5% comes from a lack of power.
Compression is good, plugs are new, half the injectors are new. Cap rotor and wires look good, although I ordered new cap/rotor...
I'm going to replace my manifolds and risers that only have a water inlet on the bottom of the manifold with a set that has water inlet on riser and manifold. Where does the water line connect from that goes to the manifold? From pictures I've determined that the riser is fed from the thermostat...
Ok, normally I would attribute this problem to a bad riser gasket/bad manifold. But I've pulled them both and doesn't look like there's any water getting past the gaskets. But for some reason ALL the cylinders get water in them. Oil is clear. Pull the plugs, clear the water out, starts and runs...
I've looked all over and can't seem to locate a flame arrestor for my motor. It was a recent swap from a v6 2bbl to a 5.7 mpi. I currently have fashioned the 4.3 flame arrestor to fit over the throttle body including a piece of exhaust bellows and clamp, but I would like to use the right part...
Just swapped over from a v6. Has new IACV and TPS. Fresh rebuild.
Starts and idles great for a few seconds, then dies. Unplug TPS, runs at a high idle (1100 rpm or so) for as long as its unplugged.
If I shift into gear immediately after starting it runs great makes good power all the way...
Hey guys I have a Mariah shabah 202 that I rebuilt my carbed v6 (raw water cooled) in due to water ingestion/bad bearings. The motor got water in it again right after the rebuild so I bought a freshwater cooled horizon 350 mpi and just rebuilt it. Now I need a little help finishing up.
First...
