I read the directions and still cant figure out if i doing it right. It says per handle adjustment, it has a l and r on it, I thinking you turn it in the direction that you want the screw to go, but it do not seem to be working.
I just purchased a hand impact driver to free up some lower unit drain oil screws. My question is is the driver suppose to rotate after each hammer blow. I am curious if my impact drive could have arrived defective.
Rebuilt the fuel pump worked fine 4 weeks later i go and prime the primer ball and fuel comes out of the line going to the carburetor at the fuel pump, I am wondering if it could be a stuck float in the carburetor or if i need to break down the fuel pump again and check all the springs and...
I have a 1973 18hp and when you pull the choke lever it will not engage the choke. I thinking that the springs could possible be out of the right alignment. I have look at the diagram on the evinrude website already, but that doesnt show the correct way to connect all the springs. Thanks Gulf...
i have a 2000 25 johnson that was converted from a tiller to a remote there is now to holes where the start button and kill switch were on the motor has anyone came to this problem and found a plastic plug to fill the holes thanks
i have a newer model rma 500 bilge pump which kicks on when it senses water it works great but occasionally it will stick on like it can get the last bit of water out and will not shut off until you stop power to it, what can i do to make sure it wont stick on when i not attending the boat...
i have a 1983 whaler and have been trying to set the trailer but every time i miss and it sit wrong the trailer has 4 rollers and the bunks is there some basic steps to make rigging it easy thank gcs
model number J90TLC0S just got the boat motor and the trim and tilt motor was frozen took of the trim and tilt motor and swapped it with a working one reinstalled it work great with it hook up direct to the battery but when i hook it up to the wires on the motor i get a low power enough to make...
have a 90 1984 evinrude that need some trim and tilt work, but the motor was received with a one of the 4 bolts broken of inside the unit, i removed both bolts on the starboard side but cant get the other 1 on the port side any advice on removing the one bolt with out breaking it off and should...
i have a 2000 Johnson 25 that was originally a tiller than it was switch to a remote and i am looking for the clip that hold the throttle cable from poping of at wot if someone know the part number or where to find it i would appreciate it gcs
just got an 1983 18' center console sea squirt needs alot of work before i put the time into it i like to see what any past owner thought and if they are a quality boat, if they are unsinkable like a whaler,and some other facts, it dose not have self bailer so look like it needs a good bilge
1984 johnson 90 horse just did a rebuild on the carbs thanks iboats "great forum for now on i buy my parts here" runs great with the manual valve open red valve facing toward the water but you close it dies at idle but if your up on plane it will run fine with it closed and a little faster ...
older boat trailer that has the swing up frame doing a rebuild and need to find a spring that hold the frame from swinging up when not launching have had a hard time trying to located online
can a rectifier be half bad put out a little charge or is it a all or none type deal and also i have the 4 wire 4-5 amp rectifier and was wondering how much voltage i should see, the battery was completely dead like 11.74 and when i went to full throttle it went to like 12.18 is that enough to...
all right i am going try to fix the rectifier for once and all tested it and no charge while running. how hard it it to install a new one i see on Johnson parts catalog they run about 50 dollars would you suggest having a mechanic install or should i do it myself neighbor has service manual...