I am having problems with my motor I prime the motor and it runs fine until float bowl on fuel bracket is empty. The bowl is not refilling. I replaced the cover the float and needle valve in the bowl and also tried two different tanks and two different sets of fuel lines. Still has the same...
I need some help I have a 1990 johnson 150 hp GT. From a cold start only it will not have fire after trying and letting it sit awhile it will crank up and run great and I can stop and fish and it will crank the rest of the day. I will try the next day and no fire then keep trying and it will...
I recently got a Johnson 150 gt I ran a decarb and then changed plugs. After running a little while I pulled plugs and noticed one was full of dry carbon buildup. Motor has a miss so I did a compression check also and readings on all cylinders were between 90-93psi.
I have a 1990 yamaha 30 hp. My problem is I have to put a crack in the fuel tank cap to keep it from running out of fuel. I have new fuel tanks and fittings. I also have new fuel lines and fuel pump. Motor runs great when I leave a crack in the fuel tank. I know it should be closed can anyone...
I have a mercury 25 hp not sure of the year. I looked up the serial number and it say a 92 but the carb has the square plastic bowl on the bottom. My question is what should the float level be set at and also the needle valve is obsolete but i was told that another motor has the same needle...
Hi Guys I have a problem with my 1990 Yamaha 30hp. A little history first I got this motor from a guy that had it stored up for a few years. I have an identical motor already but short shaft version. I changed the carbs and impeller motor fires up and run great now but I am not getting any water...
I am looking for a replacement carb cover for a 40 hp Mariner 4 cyl 2 stroke outboard. If someone has one that will fit please let me know or if someone has the info on which year models and hp motors have the same cover that would be helpful as well. Thanks in advance.
I have a 40 hp Mariner outboard it runs good at idle speed and at full throttle. For some reason when I get between 25% to 75% throttle it has moments where it has a little sputter occasionally. Any ideas of what can cause this abnormal behavior? Thanks for any info.
