No steering ideas at the moment, the wheels are wide apart so it makes steering a little bit difficult as both wheels are drive wheels
I havent painted it just yet i have used it around 8 times i also changed the 2 relays to a large winch relay
Hey Guys here's a video i made converting a direct drive mini mover 2 trailer mover to dual offroad wheels, i used 10mm and 16mm plate steel i welded it together with 2.4mm arc welding rods
Its pushing a V19 fibreglass center console in the video around 4400lb up a 5 degree incline on light dry...
I faired one side section quiet afew months back and only just sanded it back for the hull to be painted
Lastly a pic of how the boat turned out with a small homemade windscreen
Starting to work on the paint job over the past few days i have been applying paint stripper to remove the old peeling and cracking paint on the top deck
I used the pressure washer today to blast off most of it very hard going as the paint is very thick actually looks like house paint
Applied...
Stringers have to be the most difficult part of a boat repair so take your time
If u can gut the whole hull now it will give you assurance in years to come it was all rebuilt, what you don't want to happen is to do a part repair one stringer than put a floor down to find out in 2 years the...
Took her out in open water yesterday riding over the swell at around 20knots she rode beautiful the bow done all the work, she was very stable and predictable in over taking swell in a following sea, she drove very stable going across the swell at an angle, she even done well over taking a...
I done my 19ft transom in less than 50 hours, what took the most time was the epoxy resin "curing" which is not calculated in the rebuild time, each epoxy laminate takes 48 hours to cure for sanding
You can cut the outside transom skin 3-4 inches in around the outside than chip out all the...