Recent content by earlybird

  1. E

    Power loss at full throttle

    Have Chrysler OB 1976 35HP, last 1/2 inch of throttle bogs motor down, when checking linkage found no spark advance movement after that point but carburater linkage continues to move, there is room for adjustment to the spark advance linkage, would this possibly be a solution to my problem?
  2. E

    Need year of motor and have carb problem

    Help!!! have Mariner outboard, is 30hp, data plate shows 30AE, then 689 L 402059, carb has word Teikei stamped on it, engine runs fine but gas runs out overflow at top of carb, gas flow slows down when engine speed is increased, all help appreciated.
  3. E

    59 Evinrude points setting help

    Have 59 Evinrude 4 cylinder with belt driven distributor, Model # V4SL-11, need to know how to set points, also where to buy parts, all help appreciated
  4. E

    Evinrude-no spark, need year motor made

    Just bought old Evinrude 50 Starflite, no fire to plugs, need manual but cannot find year was made, Model # V4SL-11, Serial # 1921255, appreciate any help
  5. E

    35 HP Chrysler flooding problem

    Haveing problem with lower cyl overloading with gas when motor is turned off. When I restart it runs real rough for a few minutes then settles down. Anyone have any ideas.
  6. E

    help identify old boat

    Was given old boat and was told it is a jonboat, would like to make sure. It is 12 ft long, with a closed bow,windshield, boat is fiberglass, no data plate anywhere, was told it is 1962 model, is v-bottom. appreciate any help
  7. E

    tilt & trim

    new to boating, what purpose is tilt of motor for? also what plugs go in 1972 35hp chrysler, thanks in advance for info
  8. E

    35 HP Chrysler shift problem

    Need help! recently bought 35 HP Chrysler outboard, Model # 357HP, Serial # 1771, can someone tell me what year motor was made and correct plug and gap, also thumps hard when shifting out of neutral, does it when going into forward or reverse, has single lever shifter with 2 cables, any help...
  9. E

    RE: reply from corm

    RE: reply from corm hello corm, thanks for reply, tank is white with green raised triangle around gas cap and green center cap on magneto, does not have a seperate exhaust pipe, it is part of unit that bottom is attached to, does have water inlet port on front of same unit and water exhausts...
  10. E

    help identify old motor

    Help!!! Recently bought old outboard, has no ID plate on it, is single 2 1/8 diameter piston 2-cycle w/ egg shaped fuel tank wraped around magneto, pull rope wraps around top of mag and comes off after pulling, is water-cooled, has Eisemann Magneto Corp,Brooklyn,NY w/Model #61-M and Serial #47-B...
See more
Top