I believe the motor on 1993 Jazz is a 90 Force, you might try to look if it has been used in any other jet boats. Or try to see if reverse gate for any of the jet skies could be fitted for your boat.
Jetski has a good compression, about 120psi on both cylinders. Cranks fine, but im getting a single spark and nothing after. Changed the stator, still the same issue. This time the stator is used Kawasaki original. Mechanic said the ebox is good. I'm running out of ideas.
The battery is a little low, try to fully charge it before starting again. And if you shortcurcuit the poles of the starter solenoid, it should at least crank a little, clicking means your solenoid might be bad. But it is easy repair and pretty cheap one. Much cheaper than replacing the whole...
I am trying to get this jet ski to run. Original magneto had 2 wires green and purple coming to the cdi unit. Several replacement CDI units that came with this jet ski as well as the ones i saw online had 4 wires. So i decided to change the stator to match CDI unit. However, i got an aftermarket...
I just purchased a pair of jetskies. Technically one 1995 Kawasaki SS jetski with a 750cc engine and the other PWC is 1995 Yamaha Waveraider 1100. Later is running like a beast and has no issues, but Kawasaki has a problem with idle or low gas running. It chokes and feels like a strange push...
Did this with a friend. I was lowering down the top unit and he was adjusting the rings. After about 20 minutes all pistons were in and all rings were properly seated. However a couple words of caution, trying to install the top unit while the lower unit is still in the bay is a waste of time...
Im thinking about buying a jet ski in Nevada, but am not sure what are the title laws there. In Arizona it is just a Game and Fish Department registration part for any boat or PWC. In other states the rules are different so im kinda concerned as to what to look for. The seller showed this, but i...
I just bought a pair of jetskies on a nice aluminum trailer that i would love to keep. Original wheels are 5.30-12 and they are old and cracked. The hub is 4.5-5 and my set of 14" wheels with nice and new Carlisle tires fit the hole pattern. Unfortunately, the width of these tires make them rub...
I think my buddy is now looking for a coupler in his driveway or in the front yard. I told him to look at the 30 gal trash tank filled up with beer cans and liquor bottles first. I hate when drunk people are trying to do stuff that they have no clue about and being helpful. It took me two hours...